欢迎访问《兵工学报》官方网站,今天是

兵工学报 ›› 2012, Vol. 33 ›› Issue (7): 782-787.doi: 10.3969/j.issn.1000-1093.2012.07.003

• 论文 • 上一篇    下一篇

液力变矩器叶片参数的正交试验优化设计

罗虹, 李英强, 李兴泉, 王腾腾, 孙新龙   

  1. (重庆大学 机械传动国家重点实验室, 重庆 400030)
  • 收稿日期:2010-12-10 修回日期:2010-12-10 上线日期:2017-02-28
  • 作者简介:罗虹(1955—),男,副教授,硕士生导师
  • 基金资助:
    重庆市科技攻关重大资助项目(CSTC,2009AC6002)

Optimal Design of Vanes in Hydrodynamic Torque Converter Based on Orthogonal DOE

LUO Hong, LI Ying-qiang, LI Xing-quan, WANG Teng-teng, SUN Xing-long   

  1. (State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing 400030, China)
  • Received:2010-12-10 Revised:2010-12-10 Online:2017-02-28

摘要: 在计算流体动力学中,采用正交试验方法对液力变矩器的叶片参数进行优化。研究了优化变量的选择方法。根据一维设计理论并结合计算流场的分布特征,选取对变矩器性能影响显著的叶片参数作为优化变量。采用正交试验方法分别以起动变矩比、最高效率为单目标进行优化,得到最优目标值。在此基础上构建综合目标函数进行优化。对某变矩器优化后起动变矩比和最高效率分别提升了1.5%、7.3%,表明该方法效果较好,具有工程实用价值。

关键词: 流体传动与控制, 液力变矩器, 计算流体力学, 叶片参数, 优化设计

Abstract: To improve the performance of torque converter, some blade parameters were selected as variables and then optimized by orthogonal DOE (design of experiment) which based on the three dimensional flow simulation. The variables were selected through theory of hydrodynamic torque converter design and the analyzing of flow field in it. Firstly, optimal models respectively taking the stall torque ratio and top efficiency as target function were set up to get two optimal target values. Then, these two values were used to form a new function as target for next optimization. The result indicates that the stall torque ratio and top efficiency increase by 7.3% and 1.5%, respectively after the optimization proves the efficiency of this approach and its value to engineering.

Key words: turn and control of fluid, hydrodynamic torque converter, computational fluid dynamics, blade parameter, optimal design

中图分类号: