2，4-二硝基苯甲醚基熔铸炸药宏细观烤燃响应特性数值分析

doi:10.3969/j.issn.1000-1093.2022.02.006

摘要/Abstract

摘要： 2,4-二硝基苯甲醚(DNAN)/奥克托今(HMX)熔铸炸药在烤燃过程中会发生DNAN熔化、HMX晶型转变等特征现象。为研究其烤燃响应特性，发展了DNAN熔化-化学反应动力学模型，结合HMX四步化学反应动力学模型，从宏观和细观尺度研究了DNAN基熔铸炸药的熔化、晶型转变及点火响应。宏观计算结果表明：DNAN在约377.00 K熔化，HMX在约450.00 K晶型转变，点火温度为531.34 K，点火位置位于装药上下端面与侧面夹角处环形区域，计算点火时间与实验结果误差为0.5%。基于宏观点火区域进行细观计算，发现点火位置位于HMX炸药晶粒，并得到DNAN熔化、HMX晶型转变等细观分布演化规律，即不同时刻，液相DNAN统计分布呈U形分布，δ-HMX近似正态分布。表明DNAN基熔铸炸药烤燃宏细观数值计算对深入理解含能材料的热点火机理具有重要意义。

关键词: 熔铸炸药, 2, 4-二硝基苯甲醚, 烤燃, 点火响应, 细观计算

Abstract: The melting of DNAN and the phase transformation of HMX crystal occur in 2,4-dinitroanisole (DNAN)/octogen (HMX) melt-cast explosives during cook-off test. A melting reaction kinetics model is developed for DNAN, and a four-step reaction kinetics model of HMX is used to study the melting, phase transformation and ignition response of DNAN-based melt-cast explosives at the macro-meso scale. Macroscale calculation shows that DNAN melts at about 377.00 K, HMX undergoes a phase transformation at about 450.00 K, and the ignition temperature is 531.34 K. The ignition position locates at the annular area between the upper and lower ends and the side of the explosive, the error between the calculated and experimental ignition times is 0.5%. The mesoscale calculation results based on the macroscopic ignition area show that the ignition position locates at HMX crystal, and the evolution rules of DNAN melting and HMX phase transformation are obtained: at different times, the statistical distribution of liquid-phase DNAN is U-shaped, and δ-HMX is approximately normal. The macro-meso scale cook off simulations of DNAN-based melt-cast explosives are of great significance for understanding the thermal ignition mechanism of energetic materials.

Key words: melt-castexplosive, 2,4-dinitroanisole, cook-off, ignitionresponse, mesoscopiccalculation

中图分类号:

TQ560.1

刘瑞峰, 王昕捷, 黄风雷, 黄亨建. 2，4-二硝基苯甲醚基熔铸炸药宏细观烤燃响应特性数值分析[J]. 兵工学报, 2022, 43(2): 287-296.

LIU Ruifeng, WANG Xinjie, HUANG Fenglei, HUANG Hengjian. Macro-meso-scale Cook-off Simulations of DNAN-based Melt-cast Explosives[J]. Acta Armamentarii, 2022, 43(2): 287-296.

参考文献

［1］曹端林, 李雅津, 杜耀, 等. 熔铸炸药载体的研究评述 [J]. 含能材料, 2013, 21(2): 157-165.
CAO D L, LI Y J, DU Y, et al. Review on carriers for melt-cast explosives[J]. Chinese Journal of Energetic Materials, 2013, 21(2): 157-165. (in Chinese)
[2］王红星, 王晓峰, 罗一鸣. 不敏感熔铸炸药的研究现状及发展趋势[J]. 爆破器材, 2021, 50(1): 1-9.
WANG H X, WANG X F, LUO Y M. Research status and development trend of insensitive melt-cast explosive[J]. Explosive Materials, 2021, 50(1): 1-9. (in Chinese)
[3］陈朗, 李贝贝, 马欣. DNAN炸药烤燃特征[J]. 含能材料, 2016, 24(1): 27-32.
CHEN L, LI B B, MA X. Research on the cook-off characteristics of DNAN explosive[J]. Chinese Journal of Energetic Materials, 2016, 24(1): 27-32. (in Chinese)
[4］ HENSON F B, ASAY W B, SMILOWITZ B L, et al. Ignition chemistry in HMX from thermal explosion to detonation[J]. AIP Conference Proceedings, 2002, 620(1): 1069-1073.
[5］ MCGUIRE R R, TARVER C M. Chemical-decomposition models for the thermal explosion of confined HMX, TATB, RDX, and TNT explosives [C]∥Proceedings of the 7th Symposium (International) on Detonation. Annapolis. MD, US: Naval Surface Weapons Center, 1981: 56-64.
[6］ PERRY W L, GUNDERSON J A, BALKEY M M, et al. Impact-induced friction ignition of an explosive: infrared observations and modeling[J]. Journal of Applied Physics, 2010, 108(8): 084902.
[7］马欣. 高能混合炸药热反应特征和规律研究[D]. 北京: 北京理工大学, 2014: 94-118.
MA X. Study on thermal reaction characteristics and rules of high energy mixed explosives[D]. Beijing: Beijing Institute of Technology, 2014: 94-118. (in Chinese)
[8］马欣, 陈朗. HMX基混合炸药烤燃特性及多步热反应计算[J]. 兵工学报, 2015, 36(增刊1): 334-342.
MA X, CHEN L. Research on cook-off characteristics and multi-step thermal decompostion calculation of HMX-based explosive[J]. Acta Armamentarii, 2015, 36(S1): 334-342. (in Chinese)
[9］ VOLLER V R, SWAMINATHAN C R. General source-based method for solidification phase change[J]. Numerical Heat Transfer, Part B: Fundamentals, 1991, 19(2): 175-189.
[10］ XING X L, ZHAO F Q, MA S N, et al. Specific heat capacity, thermal behavior, and thermal hazard of 2, 4-dinitroanisole[J]. Propellants, Explosives, Pyrotechnics, 2012, 37(2): 179-182.
[11］陈朗, 马欣. 熔铸混合炸药烤燃特征及热反应计算分析 [C]∥2014(第六届)含能材料与钝感弹药技术学术研讨会论文集. 四川, 成都: 中国工程物理研究院, 2014: 392-401.
CHEN L, MA X. Cook-off characteristics and thermal response calculation analysis of melt-cast mixed explosive[C]∥Proceedings of the 6th Symposium on Energetic Materials and Insensitive Munitions. Chengdu, Sichuan: China Academy of Engineering Physics, 2014: 392-401. (in Chinese)
[12］冯长根. 热爆炸理论[M]. 北京: 科学出版社, 1988:108.
FENG C G. Thermal explosion theory[M]. Beijing: Science Press, 1988: 108. (in Chinese)
[13］王福军. 计算流体动力学分析[M]. 北京: 清华大学出版社, 2004: 204.
WANG F J. Computational fluid dynamics analysis[M]. Beijing:Tsinghua University Press, 2004: 204. (in Chinese)
[14］ ANSYS Inc.. ANSYS FLUENT 14.0 User's Guide[M]. Canonsburg, PA, US: ANSYS, Inc., 2011, 10: 813-818.
[15］ HOBBS M L, KANESHIGE M J, ERIKSON W W, et al. Gas retention in an HMX-based explosive (LX-14)[J]. Science and Technology of Energetic Materials, 2018, 79(2): 35-42.
[16］ LI S R, DUAN Z P, GAO T Y, et al. Size effect of explosive particle on shock initiation of aluminized 2,4-dinitroanisole (DNAN)-based melt-cast explosive[J]. Journal of Applied Physics, 2020, 128(12): 125903.

[1]	王新宇, 姜春兰, 王在成, 方远德. 烤燃条件下JEO聚能装药战斗部泄压结构研究[J]. 兵工学报, 2024, 45(1): 1-14.
[2]	余毅磊, 王晓东, 任文科, 高光发. 三层组合陶瓷复合装甲的抗侵彻性能及其损伤机制[J]. 兵工学报, 2024, 45(1): 44-57.
[3]	李云飞, 高鑫, 陈鹏万, 刘开源. TiB₂/B₄C复相陶瓷自蔓延热爆炸烧结与性能表征[J]. 兵工学报, 2024, 45(1): 26-34.
[4]	寇永锋, 杨坤, 张斌, 肖迤文, 鲁建英, 陈朗. 基于烤燃实验和数值模拟的战斗部装药热安全性[J]. 兵工学报, 2023, 44(S1): 41-49.
[5]	张坤, 智小琦, 肖游, 王帅. 一维慢速烤燃模型点火点位置及其温度的理论计算[J]. 兵工学报, 2023, 44(4): 1139-1147.
[6]	张鑫, 林凡, 沈鑫杰. 基于改进SOGI-FLL的旋转弹舵机滞后测试方法[J]. 兵工学报, 2023, 44(2): 428-436.
[7]	尤浩, 常新龙, 赵久奋, 张有宏, 王顺宏. 带攻击角度约束的三维领弹-从弹时间协同制导律[J]. 兵工学报, 2023, 44(11): 3369-3381.
[8]	杨春伟, 刘炳琪, 王继平, 邵节, 韩治国. 基于注意力机制的高超声速飞行器LSTM智能轨迹预测[J]. 兵工学报, 2022, 43(S2): 78-86.
[9]	李博，王博，韩京冶，杨宗睿，栗霖雲，傅畅之. 基于车载计算机的红外图像移动目标检测[J]. 兵工学报, 2022, 43(S1): 66-73.
[10]	余毅磊, 王晓东, 任文科, 马铭辉, 蒋招绣, 高光发. 陶瓷/金属复合靶受12.7mm穿甲燃烧弹侵彻时弹靶破碎特征[J]. 兵工学报, 2022, 43(9): 2307-2317.
[11]	王晓东, 徐永杰, 董方栋, 王昊, 郑娜娜. 凯夫拉与陶瓷复合结构抗侵彻性能数值仿真[J]. 兵工学报, 2022, 43(9): 2360-2366.
[12]	李淑睿，段卓平，白志玲，张旭，黄风雷. 2，4-二硝基苯甲醚基熔铸含铝炸药冲击起爆特性[J]. 兵工学报, 2022, 43(6): 1288-1294.
[13]	阚润哲，聂建新，郭学永，闫石，焦清介，张韬. 不同铝氧比CL-20基含铝炸药深水爆炸能量输出特性[J]. 兵工学报, 2022, 43(5): 1023-1031.
[14]	江胜华. 基于磁偶极子的2阶磁场梯度张量缩并方法[J]. 兵工学报, 2022, 43(12): 3122-3131.
[15]	李严星，王琳，闫志维，安瑞，周哲，宁子轩，程焕武，程兴旺. 不同组织Ti6321钛合金在低温高应变速率下的变形和断裂行为[J]. 兵工学报, 2022, 43(12): 3221-3227.