锥头圆柱体高速入水空泡深闭合数值模拟研究

doi:10.3969/j.issn.1000-1093.2014.09.018

兵工学报 ›› 2014, Vol. 35 ›› Issue (9): 1451-1457.doi: 10.3969/j.issn.1000-1093.2014.09.018

锥头圆柱体高速入水空泡深闭合数值模拟研究

马庆鹏，魏英杰，王聪，曹伟，陈超倩

（哈尔滨工业大学航天学院, 黑龙江哈尔滨 150001）

收稿日期:2013-12-03 修回日期:2013-12-03 上线日期:2014-11-03
作者简介:马庆鹏（1988—），男，博士研究生
基金资助:
哈尔滨市科技创新人才专项基金项目（2013RFLXJ007）；中央高校基本科研业务费专项（HIT.NSRIF.201159）

Numerical Simulation of Deep Closure of High-speed Water Entry Cavity of Cone-cylinder

MA Qing-peng, WEI Ying-jie, WANG Cong, CAO Wei, CHEN Chao-qian

(School of Astronautics, Harbin Institute of Technology, Harbin 150001, Heilongjiang, China)

Received:2013-12-03 Revised:2013-12-03 Online:2014-11-03

摘要/Abstract

摘要： 考虑入水过程的空化效应，基于有限体积法和流体体积（VOF)方法求解气、汽、液三相流动的RANS方程，并引入动网格技术，对小型锥头圆柱体高速自由垂直入水问题开展了数值模拟研究，得到了入水空泡演化过程以及深闭合过程空泡流场的流动特性和压力分布特性。将入水弹道及空泡形态的数值结果与理论分析结果进行了对比，验证了数值计算结果的正确性。对入水空泡深闭合的研究结果表明，高速条件下入水空泡的深闭合发生在面闭合之后、自由液面以下较深位置，空泡在深闭合后迅速溃灭。同时，在空泡内外多相流场的相互作用下，空泡壁尚未完全收缩至轴线便已闭合，闭合区域出现高压区，压力极值始终出现在空泡分离点处直至空泡溃灭。

关键词: 流体力学, 多相流, 高速入水, 空泡, 深闭合

Abstract: Numerical simulation for modeling the cavity formation process of high-speed water entry is performed. Finite volume method is introduced to discretize the Reynolds averaged Navier-Stokes equations. Results on the velocity and trajectory show good agreement with the results obtained by the analytical model. The flowing characteristics and pressure distribution of the deep closure stage are also studied. Results show that the deep closure occurs after surface closure and at a deep penetration depth for high-speed water entry problem, and the cavity collapses very quickly after the deep closure. The cavity closes under the effects of multiphase flow before the cavity wall shrinks completely, which induces high pressure around the deep closure area, and the maximum pressure always act on the separating points until the cavity collapses.

Key words: fluid mechanics, multiphase flow, high-speed water entry, cavity, deep closure

中图分类号:

TV131.2

马庆鹏，魏英杰，王聪，曹伟，陈超倩. 锥头圆柱体高速入水空泡深闭合数值模拟研究[J]. 兵工学报, 2014, 35(9): 1451-1457.

MA Qing-peng, WEI Ying-jie, WANG Cong, CAO Wei, CHEN Chao-qian. Numerical Simulation of Deep Closure of High-speed Water Entry Cavity of Cone-cylinder[J]. Acta Armamentarii, 2014, 35(9): 1451-1457.

参考文献

［1］ Worthington A M, Cole R S. Impact with a liquid surface studied by the aid of instantaneous photography［J］. Philosophical Transactions of the Royal Society, 1900, 194(A): 175-200.
［2］ May A. Water entry and the cavity-running behavior of missiles,AD A020429［R］. Dayton: ASTIA, 1975.
［3］ Gilbarg D, Anderson R A. Influence of atmospheric pressure on the phenomena accompanying the entry of spheres into water ［J］. Journal of Applied Physics, 1948, 9(2): 127-139.
［4］ May A, Woodhull J C. Drag coefficients of steel spheres entering water vertically ［J］. Journal of Applied Physics, 1948, 19(12): 1109-1121.
［5］ May A, Woodhull J C. The virtual mass of a sphere entering water vertically ［J］. Journal of Applied Physics, 1950, 21(12): 1285- 1289.
［6］ May A. Effect of surface condition of a sphere on its water-entry cavity ［J］. Journal of Applied Physics, 1951, 22(10): 1219-1222.
［7］ ZHAO R, Faltinsen O. Water entry of two-dimensional bodies ［J］. Journal of Fluid Mechanics, 1993, 246: 593-612.
［8］ Semenov A, Iafrati A. On the nonlinear water entry problem of

asymmetric wedges ［J］. Journal of Fluid Mechanics, 2006, 547: 231-256.
［9］ Sun S L, Wu G X. Oblique water entry of a cone by a fully three-dimensional nonlinear method ［J］. Journal of Fluids and Structures, 2013, 42: 313-332.
［10］ Lundstrom E A, Fung W K. Fluid dynamic analysis of hydraulic ram Ⅲ, AD 031644［R］. Dayton: ASTIA, 1976.
［11］ Lee M, Longoria R G, D E Wilson. Cavity dynamics in high-speed water entry ［J］. Physics of Fluids, 1997, 9(3): 540-550.
［12］王聪，何春涛，权晓波，等. 空气压强对垂直入水空泡影响的数值研究［J］. 哈尔滨工业大学学报，2012，44(5)：14-19.
WANG Cong, HE Chun-tao, QUAN Xiao-bo, et al. Numerical simulation of the influence of atmospheric pressure on water-cavity formed by cylinder with vertical water-entry［J］. Journal of Harbin Institute of Technology, 2012, 44(5): 14-19. (in Chinese)
［13］何春涛，王聪，闵景新，等. 回转体匀速垂直入水早期空泡数值模拟研究［J］. 工程力学，2012，29(4)：237-243.
HE Chun-tao, WANG Cong, MIN Jing-xin, et al. Numerical simulation of early air-cavity of cylinder cone with vertical water-entry［J］. Engineering Mechanics, 2012, 29(4): 237-243. (in Chinese)
［14］ Menter F R. Two-equation eddy-viscosity turbulence models for engineering applications［J］. AIAA-Journal, 1994, 32(8): 1598-1605.

[1]	张亮, 胡常莉, 吴小安. 超空泡航行体锥段结构对其尾拍运动影响的数值研究[J]. 兵工学报, 2024, 45(3): 828-836.
[2]	郭庆, 罗凯, 耿少航, 秦侃. 含不凝气体的蒸汽凝结换热数值研究[J]. 兵工学报, 2023, 44(7): 2080-2091.
[3]	刘喜燕, 袁绪龙, 罗凯, 鲁娜. 跨介质航行器出入水连续弹道试验与仿真[J]. 兵工学报, 2023, 44(5): 1225-1236.
[4]	张曼曼, 姜毅, 史少岩, 邓月光. 喷水系统对W形地下空间热发射流场的影响[J]. 兵工学报, 2023, 44(4): 1158-1170.
[5]	刘如石, 郭则庆, 张辉. 尾部形状对超空泡射弹尾拍运动影响的数值研究[J]. 兵工学报, 2023, 44(10): 2984-2994.
[6]	张春，王宝寿. 水下航行体超声速射流与尾空泡耦合作用初期的流场特性[J]. 兵工学报, 2022, 43(7): 1685-1694.
[7]	贾启明，姜毅，杨莹，赵子熹，王志浩. 新型推力可控垂直发射装置及其内弹道规律[J]. 兵工学报, 2022, 43(7): 1596-1605.
[8]	古鉴霄，党建军，黄闯，李代金，刘富强. 衡重参数对超空泡射弹有效射程的影响[J]. 兵工学报, 2022, 43(6): 1376-1386.
[9]	汪泰霖, 王野, 张富毅, 陈慧岩, 王国玉. 水陆两栖车矢量喷口装置设计与仿真[J]. 兵工学报, 2022, 43(4): 826-850.
[10]	李宜果，王聪，武雨嫣，曹伟，卢佳兴，何乾坤. 跨介质航行体高速入水空泡壁面运动特性[J]. 兵工学报, 2022, 43(3): 574-585.
[11]	杨晓光，党建军，王鹏，王亚东，陈诚，李得英. 波浪对航行体高速入水载荷特性影响[J]. 兵工学报, 2022, 43(2): 355-362.
[12]	朱毅飞, 林德福, 莫雳, 叶建川. 四旋翼无人机旋翼对机身非定常气动干扰特性[J]. 兵工学报, 2022, 43(2): 410-422.
[13]	权晓波，尤天庆，张晨星，王凡瑜，孔德才. 水下垂直发射航行体尾空泡振荡演化特性[J]. 兵工学报, 2021, 42(8): 1728-1734.
[14]	袁绪龙，栗敏，丁旭拓，任伟，周方旭. 跨介质航行器高速入水冲击载荷特性[J]. 兵工学报, 2021, 42(7): 1440-1449.
[15]	刘双, 何广华, 王威, 高云. 附体对分层流中潜艇水动力特性的影响[J]. 兵工学报, 2021, 42(1): 108-117.

锥头圆柱体高速入水空泡深闭合数值模拟研究

Numerical Simulation of Deep Closure of High-speed Water Entry Cavity of Cone-cylinder

PDF

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价