武器系统预防性维修间隔期的多目标决策研究

doi:10.3969/j.issn.1000-1093.2015.06.018

摘要/Abstract

摘要： 为解决武器系统故障率难以用时间为自变量进行表达的问题，鉴于武器系统的故障与射弹量密切相关，以间隔射弹量确定预防性维修的时机在实际中更易于操作，且间隔射弹量数据易于统计，在利用现场采集故障数据的基础上，建立了以射弹量为自变量描述武器系统故障率的故障率模型，并利用该故障率模型对使用可用度和维修费用这两个重要目标进行了解析表达。采用多目标粒子群算法，针对某型武器系统，以使用可用度和维修费用为优化目标，进行优化决策，得到了符合要求的满意解。

关键词: 兵器科学与技术, 威布尔分布, 预防性维修, 维修费用, 使用可用度

Abstract: To solve the problem of that the failure rate of the weapon system is difficult to be described with time as an independent variable, a model is established by using the amount of intervally fired projectiles as the independent variable to describe the failure rate of the weapon system. Since the failures of weapon systems are closely related to the the amount of intervally fired projectiles, the preventive maintenance opportunity determined by the amount of intervally fired projectiles is easy to operate in practice, and the statistical data of the amount of intervally fired projectiles are retained easily. Based on the failure data of a weapon system, Ao (Operational availability) and EMC (Expected maintenance cost), which are two important objectives, are analytically expressed by the proposed failure rate model. For these two objectives, the optimized decision is made with MOPSO, and the satisfactory solutions meeting the requirements are obtained.

Key words: ordnance science and technology, Weibull distribution, preventive maintenance, maintenance cost, operational availability

中图分类号:

都业宏，郁浩，赵静，张扬，杨春来. 武器系统预防性维修间隔期的多目标决策研究[J]. 兵工学报, 2015, 36(6): 1089-1095.

DU Ye-hong, YU Hao, ZHAO Jing, ZHANG Yang, YANG Chun-lai. Multi-objective Decision of Preventive Maintenance Intervals of Weapon Systems[J]. Acta Armamentarii, 2015, 36(6): 1089-1095.

参考文献

［1］ Kumar U D, Crocker J. 可靠性、维修性与后勤保障——寿命周期方法［M］.刘庆华，宋宁哲，刘根，等，译. 北京：电子工业出版社，2010.
Kumar U D, Crocker J. Reliability, maintenance and logistic support: a life cycle approach［M］.LIU Qing-hua，SONG Ning-zhe，LIU Gen, et al, translated. Beijing: Publishing House of Electronics Industry, 2010. (in Chinese)
［2］于永利，郝建平，杜晓明，等.维修性工程理论与方法［M］.北京: 国防工业出版社，2007.
YU Yong-li, HAO Jian-ping, DU Xiao-ming, et al. Maintainability engineering theory and methods［M］. Beijing: National Defense Industry Press, 2007. (in Chinese)
［3］宋太亮, 张宝珍, 丁利平,等. GJB451A—2005可靠性维修性保障性术语［S］. 北京：中国人民解放军总装备部, 2005.
SONG Tai-liang, ZHANG Bao-zhen, DING Li-ping, et al. GJB451A—2005 Reliability, maintainability and supportability terms［S］. Beijing: The PLA General Equipment Department, 2005. (in Chinese)
［4］杜青玲，李美芳，刘家科.机械设备预防维修周期的确定［J］.机床与液压，2000，28（6）：92-93.
DU Qing-ling, LI Mei-fang, LIU Jia-ke. Decision on the period of preventive maintenance about mechanical equipment［J］. Machine Tool & Hydraulics, 2000，28(6): 92-93. (in Chinese)
［5］ SUN Y，MA L，MATHEW J. Failure analysis of engineering systems with preventive maintenance and failure interactions ［J］. Computers & Industrial Engineering，2009，57（2）：539-549.
［6］申桂香，谷东伟，张英芝，等.数控机床最佳预防维修间隔时间的确定［J］. 重庆大学学报，2012,35(1):7-10.
SHEN Gui-xiang, GU Dong-wei, ZHANG Ying-zhi, et al. Optimal preventive maintenanace interval period of CNC［J］. Journal of Chongqing University，2012, 35(1):7-10. (in Chinese)
［7］ Moubray J. Reliability-centered maintenance II［M］.US：Industrial Press, 1997.
［8］邵延君. 基于故障预测的武器装备系统预防性维修策略研究［D］. 太原，中北大学，2013：9-48.
SHAO Yan-jun. Weapon equipment preventive maintenance strategy reaearch［D］. Taiyuan：North University of China，2013:9-48. (in Chinese)
［9］王灵芝. 以可靠性为中心的高速列车设备维修决策支持系统研究［D］. 北京，北京交通大学，2011：31-60.
WANG Ling-zhi. Research on reliability-centered maintenance decision and support system for high-speed train equipment［D］, Beijing： Beijing Jiaotong University, 2011:31-60. (in Chinese)
［10］张耀辉, 郭金茂, 单志伟,等. 装备预防性维修的维修级别逻辑决策分析方法［J］. 装甲兵工程学院学报，2008,22(5):40-44.
ZHANG Yao-hui, GUO Jin-mao, SHAN Zhi-wei, et al. Maintenance level logic decision analysis method of preventive maintenance［J］. Journal of Academy of Armored Force Engineeing,2008, 22(5):40-44. (in Chinese)
［11］余勃彪，侯健. 基于威布尔模型的舰炮武器预防性维修系统构建与优化［J］. 机械，2012,39(5):29-32.
YU Bo-biao，HOU Jian. Study on the construction for the preventive maintenance system of naval gun weapon system［J］. Machinery, 2012,39(5):29-32. (in Chinese)
［12］李剑涛, 蒋里强, 黄立坡. 装备最佳预防性维修间隔时间研究［J］. 装备指挥技术学院学报，2004,15(3):26-29.
LI Jian-tao, JIANG Li-qiang, HUANG Li-bo. Study on the interval in the best equipment preventive maintenance［J］. Journal of the Academy of Equipment Command & Technology. 2004,15(3): 26-29. (in Chinese)
［13］王超,王金. 机械可靠性工程［M］.北京：冶金工业出版社，1992.
WANG Chao,WANG Jin. Mechanical reliability engineering［M］. Beijing: Metallurgical Industry Press, 1992.(in Chinese)
［14］ Kennedy J，Eberhart R C. Particle swarm optimization［C］∥Proceedings of IEEE Inernational Conference on Neural Networks. Piscataway: IEEE Service Center,1995:1942-1948.
［15］ Fieldsend J E, Singh S. A multiobjective algorithm based upon particle swarm optimization: an efficient data structure and turbulence［C］∥UK Workshop on Computational Intelligence. Birmingham, UK: University of Birmingham,2002: 37-44.
［16］ Mastaghin S, Teich J. Strategies for finding good local guides in multiobjective particle swarm optimization(MOPSO)［C］∥Proceedings of 2003 IEEE Swarm Intelligence Symposium. Indianapolis：IEEE, 2003:26-33.
［17］ Li X. A non-dominated sorting particle swarm optimizer for multiobjective optimization［C］∥Proceedings of the Genetic and Evolutionary Computation Conference. Berlin:Springer,2003:37-48.
［18］ Fieldsend J E. Multi-objective particle swarm optimization methods［D］. Exeter, UK: Department of Computer Science, University of Exeter, 2004.
［19］ DU Ye-hong, CUI He, LI Bing, et al. Reasearch on regional coverage with LAVs on MOPSOA［J］. Journal of Information & Computional Science, 2015, 12(6): 2081-2092.

[1]	陈旭, 张书锋, 李岳, 陈循, 汪亚顺. 正态型寿命分布设备的可用性分析[J]. 兵工学报, 2024, 45(3): 986-996.
[2]	董恩志, 程中华, 王荣财, 张孝娜, 张月星, 吴巍屹, 岳帅. 考虑故障相关性的复杂二维保修装备机会维修策略[J]. 兵工学报, 2023, 44(6): 1688-1703.
[3]	周伯俊, 于传强，刘志浩，柯冰. 基于高压储能的特种车辆快速起竖技术与验证[J]. 兵工学报, 2022, 43(7): 1488-1497.
[4]	高月光，冯顺山，刘云辉，黄岐. 不同端盖厚度的圆柱形装药壳体破片初速分布[J]. 兵工学报, 2022, 43(7): 1527-1536.
[5]	娄伟鹏，郑长松，李和言，陈建文，张周立，马源. 高速《Symbol》v湿式换挡离合器排油阀临界开启和关闭压力研究[J]. 兵工学报, 2017, 38(9): 1665-1672.
[6]	王宪成，杨绍卿，马宁，赵文柱. 车辆柴油机缸套动载荷磨损计算模型研究[J]. 兵工学报, 2017, 38(9): 1673-1680.
[7]	孙皓泽，常天庆，王全东，孔德鹏，戴文君. 一种基于分层多尺度卷积特征提取的坦克装甲目标图像检测方法[J]. 兵工学报, 2017, 38(9): 1681-1691.
[8]	张玉燕，孙莎莎，王振春，曹海要，战再吉. 高速载流电枢表面瞬态温度场仿真与测量[J]. 兵工学报, 2017, 38(9): 1692-1698.
[9]	李臣明，宦超，石怀龙. 某箱式火箭炮对面目标分布式杀伤最优火力分配[J]. 兵工学报, 2017, 38(9): 1699-1704.
[10]	雷娟棉，张嘉炜，谭朝明. 小攻角下船尾外形对旋转弹丸马格努斯效应影响的数值研究[J]. 兵工学报, 2017, 38(9): 1705-1715.
[11]	李泽，闫晓鹏，栗苹，郝新红，王建涛. 扫频式干扰对调频多普勒引信的干扰机理研究[J]. 兵工学报, 2017, 38(9): 1716-1722.
[12]	张浩为，谢军伟，张昭建，宗彬锋，陈唐军. 基于混合自适应遗传算法的相控阵雷达任务调度[J]. 兵工学报, 2017, 38(9): 1761-1770.
[13]	李茂，侯海量，朱锡，黄晓明，李典，陈长海，胡年明. 结构间隙对芳纶纤维增强复合装甲结构抗侵彻性能的影响[J]. 兵工学报, 2017, 38(9): 1797-1805.
[14]	王鉴, 韩焱, 王黎明, 张丕状, 陈平. 弹丸在膛内运动的回波信号瞬时频率估计方法研究[J]. 兵工学报, 2017, 38(9): 1806-1814.
[15]	刘海鸥，张文胜，徐宜，赵梓烨. 基于核密度估计的履带车辆传动轴载荷谱编制[J]. 兵工学报, 2017, 38(9): 1830-1838.