Modeling and Experimental Validation of Drag Torque of Wet Multi-disk Clutch with Spline Connected Restriction in Full SpeedRange

doi:10.3969/j.issn.1000-1093.2018.09.001

Abstract

Abstract: A theoretical model is established for the analysis of offset state of friction elements under the condition of low speed difference based on the gyro effect. As for the gap shrinkage under the condition of high speed difference, a negative pressure contraction model for friction pairs is built by analyzing the oil film and the pressure on friction plates. The dynamic change of gap between the friction pairs in the whole variation range of the relative speed is then investigated. Finally, an improved model, considering the influence of dynamic change of gap between the friction pairs, is proposed to study the drag torque. The simulated and test results indicate that, under the condition of the same lubrication, the drag torque of the wet multi-plate clutch increases first and then decreases and finally increases with the rise of the rotational speed difference. The main factors influencing the drag torque are the offset of friction plate under the condition of the low speed difference (0-1 000 r/min), and the gap shrinkages under the condition of the middle and high speed differences (>1 000 r/min). Through the comparison of test results and the simulated results obtained from the improved model, the average relative error is only 6.34% under the condition of medium and high speed differences (>1 000 r/min), which can greatly improve the estimation accuracy of drag torque of wet multi-plate clutch.Key

Key words: wetclutch, dragtorque, frictionpairoffset, frictionpairgapshrinkage

CLC Number:

TJ810.3⁺21

SHI Lu-qi， MA Biao， LI He-yan， WU Jun-feng， LI Hui-zhu， YAN Xu， CHANG Fu-xiang. Modeling and Experimental Validation of Drag Torque of Wet Multi-disk Clutch with Spline Connected Restriction in Full SpeedRange[J]. Acta Armamentarii, 2018, 39(9): 1665-1674.

References

［1］ Lloyd F A. Parameters contributing to power loss in disengaged wet clutches[C]∥SAE International Off-Highway and Powerplant Congress and Exposition.Warrendale, PA, US: Society of Automotive Engineers,1974:740694.
[2］ Kato Y, Murasugi T, Hirano H, et al. Fuel economy improvement through tribological analysis of the wet clutches and brakes of an automatic transmission[C]∥Proceedings of JSAE convention proceedings. Tokyo，Japan：Society of Automotive Engineers of Japan,1993:57-60.
[3］ Hashimoto H, Wada S, Murayama Y. The performance of a turbulent-lubricated sliding bearing subject to centrifugal effect[J].Transactions of the Japan Society of Mechanical Engineers Series C, 1984, 49(446):1753-1761.
[4］ Yuan Y, Liu E A, Hill J, et al. An improved hydrodynamic model for open wet transmission clutches[J].ASME Journal of Fluids Engineering, 2007, 129(3): 333-337.
[5］ Walker P D, Zhang N, Tamba R, et al. Simulations of drag torque affecting synchronisers in a dual clutch transmission[J]. Japan Journal of Industrial and Applied Mathematics, 2011, 28(1): 119-140.
[6］马彪. 履带车辆综合传动特性的动态仿真研究[D]. 北京: 北京理工大学, 1999.
MA Biao. Study on the dynamic simulation of integrated transmission characteristics of tracked vehicles[D]. Beijing: Beijing Institute of Technology, 1999.（in Chinese）
[7］张志刚,周晓军,李永军,等. 湿式多片换档离合器带排转矩的预测模型[J]. 浙江大学学报：工学版，2011,45(4):708-713.
ZHANG Zhi-gang, ZHOU Xiao-jun, LI Yong-jun，et al. Drag torque prediction model of wet multi-disk shifting clutch[J]. Journal of Zhejiang University：Engineering Science, 2011, 45(4): 708-713. （in Chinese）
[8］ Yuan S H, Peng Z X, Jing C. Experimental research and mathematical model of drag torque in single-plate wet clutch[J]. Chinese Journal of Mechanical Engineering, 2011, 24(1):91-97.
[9］项昌乐,章颖莹,刘辉. 高转速差车用湿式离合器带排转矩特性研究[J]. 机械工程学报,2013,49(20):71-77.
XIANG Chang-le, ZHANG Ying-ying, LIU Hui. Research on drag torque of high relative speed open wet clutch of vehicle[J]. Journal of Mechanical Engineering, 2013, 49(20): 71-77.（in Chinese）

[10］杨立昆,李和言,马彪.改进的湿式离合器带排转矩模型[J].吉林大学学报：工学版，2014,44(5):1270-1275.
YANG Li-kun, LI He-yan, MA Biao. Improved drag torque model for wet clutch[J]. Journal of Jilin University：Engineering and Technology Edition，2014,44(5): 1270-1275. （in Chinese）
[11］景琦. 湿式换挡离合器带排损失特性研究[D]. 北京: 北京理工大学, 2012.
JING Qi. Study on the drag loss characteristic of wet shifting clutch[D]. Beijing: Beijing Institute of Technology, 2012. （in Chinese）
[12］刘继凯，马彪，李和言. 摩擦片表面沟槽对离合器带排转矩的影响[J]. 华中科技大学学报：自然科学版，2015,43(2): 35-39.
LIU Ji-kai, MA Biao, LI He-yan. Influence of surface grooves on friction plate on drag torque of wet clutch[J]. Journal of Huazhong University of Science and Technology：Natural Science Edition，2015,43(2): 35-39. （in Chinese）
[13］张昌芳，刘家福. 抖空竹的力学原理分析[J]. 力学与实践，2006,28(4): 89-92.
ZHANG Chang-fang, LIU Jia-fu. Analysis of mechanical principles of shaking diabolo[J]. Mechanics in Engineering, 2006,28(4): 89-92. （in Chinese）
[14］ Li H Y, Jing Q，Ma B. Modeling and parametric study on drag torque of wet clutch[C]∥ Proceedings of the FISITA 2012 World Automotive Congress. Berlin, Germany:Springer,2013:21-30.
[15］罗灯明，郑长松，侯树梅，等. 湿式换挡离合器全油膜状态下带排损失研究[J]. 汽车技术，2013(4): 30-34.
LUO Deng-ming, ZHENG Chang-song, HOU Shu-mei，et al. Research on drag loss of wet shifting clutch under full oil film condition[J]. Automobile Technology，2013(4): 30-34. （in Chinese）
[16］赵二辉，马彪，李和言，等. 转速对湿式离合器局部润滑及摩擦特性影响研究[J]. 兵工学报，2017,38(4): 625-633.
ZHAO Er-hui,MA Biao, LI He-yan, et al. Influence of rotating speed on local lubrication and friction characteristics of wet clutch[J]. Acta Armamentarii, 2017,38(4): 625-633. （in Chinese）
[17］ Hu J B, Peng Z X，Yuan S H. Drag torque prediction model for the wet clutches[J]. Chinese Journal of Mechanical Engineering，2009，22(2): 238-243.

第39卷
第9期2018 年9月兵工学报ACTA
ARMAMENTARIIVol.39No.9Sep.2018

[1]	ZHANG Lin, WEI Chao, HU Jibin, HU Qi. Rub-impact Characteristics and Drag Torque at High Circumferential Velocities in No-load Multi-plate Wet Clutch for Vehicles [J]. Acta Armamentarii, 2020, 41(7): 1270-1279.
[2]	CHENG Xiao， ZHU Maotao, TIAN Naili. Numerical Analysis of Effect of Liquid-gas Two-phase Flow on the Drag Torque Characteristics of Wet Clutch [J]. Acta Armamentarii, 2020, 41(5): 850-857.
[3]	LOU Wei-peng, ZHENG Chang-song, LI He-yan, CHEN Jian-wen, ZHANG Zhou-li, MA Yuan. Research on Critical Open and Close Pressures of an Oil Discharge Valve for High Speed Wet Shifting Clutch [J]. Acta Armamentarii, 2017, 38(9): 1665-1672.
[4]	ZHAO Er-hui, MA Biao, LI He-yan, DU Qiu, LI Hui-zhu, MA Cheng-nan. Influence of Rotating Speed on Local Lubrication and Friction Characteristics of Wet Clutch [J]. Acta Armamentarii, 2017, 38(4): 625-633.