高压共轨喷油器针阀开启与关闭过程规律研究

doi:10.3969/j.issn.1000-1093.2017.10.025

兵工学报 ›› 2017, Vol. 38 ›› Issue (10): 2069-2074.doi: 10.3969/j.issn.1000-1093.2017.10.025

高压共轨喷油器针阀开启与关闭过程规律研究

仇滔^1,2，刘天翔¹，安晓东³，雷艳¹，代贺飞¹

(1.北京工业大学环境与能源工程学院，北京 100124； 2.北京电动车辆协同创新中心，北京 100081；3. 北京理工大学机械与车辆学院，北京 100081)

收稿日期:2017-03-23 修回日期:2017-03-23 上线日期:2017-11-22
作者简介:仇滔(1976—), 男, 副教授。 E-mail: qiutao@bjut.edu.cn
基金资助:
国家自然科学基金项目（91641106）；北京市自然科学基金项目（3172007）

Research on Movement Characteristics of Needle Valve in Common Rail Injector for Diesel Engine

QIU Tao^1,2， LIU Tian-xiang¹， AN Xiao-dong³， LEI Yan¹， DAI He-fei¹

(1.College of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China; 2.Beijing Electric Vehicle Collaborative Innovation Center, Beijing 100081, China; 3.School of Mechanical Engineering, Beijing Institute of Technology, Beijing 100081, China)

Received:2017-03-23 Revised:2017-03-23 Online:2017-11-22

摘要/Abstract

摘要： 高压共轨喷油器的针阀运动规律直接决定了喷油规律和雾化效果，决定针阀运动规律的因素对改进喷油器结构以及提升雾化效果有着重要意义。自行搭建了高压共轨喷油器仿真模型；该计算模型对喷油器的控制油路中进出油节流孔和球阀区域处，有空化和无空化两个阶段的流量系数进行了优化；结合喷油器的理论分析与试验验证，研究了喷油器针阀的运动规律。结果表明：针阀开启过程分为2个阶段，第1阶段开启缓慢，第2阶段开启迅速，针阀关闭过程只有1个阶段；导致针阀开启过程出现2个阶段是由于喷油器控制室内泄油过程的节流位置由球阀开启处转到了回油节流孔；针阀关闭过程为1个阶段是由于球阀与阀座形成的间隙对控制室内回油过程起主要节流作用；轨压主要对针阀开启第2阶段有影响，而对针阀开启第1阶段与关闭阶段影响很小；随着轨压的升高，针阀开启第2阶段开启速度加快，当轨压达到一定值时，针阀开启第2阶段不再变化。

关键词: 动力机械工程, 柴油机, 喷油器, 针阀升程, 液力过程

Abstract: The movement of needle valve in the common rail injector determines the injection and atomization effect directly. The movement rule of needle valve in the common rail injector is important to improve the structure of injector and the atomization effect. A high-pressure common rail injector simulation system was built, and a calculation model was established for optimizing the flow coefficients in two stages of cavitation and non-cavitation at the oil inlet and outlet holes of high pressure common rail injector and in the ball valve area. The movement characteristics of needle valve in the common rail injector are studied through theoretical analysis and experiments. The results show that the opening process of needle valve can be divided into two stages: slow opening stage and fast opening stage. Two opening stages of needle valve are due to the transfer of the throttled position. However, the needle valve is mainly influenced by the throttled position, so the closure of the needle valve is a single-stage. Rail pressure has an effect on the second fast opening stage, but not on the slow opening stage or the closing process. The opening process speeds up with the rise of the rail pressure. When the rail pressure reaches to a certain value, the fast opening stage of needle valve remains unchanged. Key

Key words: powermachineryengineering, dieselengine, commonrailinjector, needlelift, hydraulicprocess

中图分类号:

TK 421⁺.42

仇滔，刘天翔，安晓东，雷艳，代贺飞. 高压共轨喷油器针阀开启与关闭过程规律研究[J]. 兵工学报, 2017, 38(10): 2069-2074.

QIU Tao， LIU Tian-xiang， AN Xiao-dong， LEI Yan， DAI He-fei. Research on Movement Characteristics of Needle Valve in Common Rail Injector for Diesel Engine[J]. Acta Armamentarii, 2017, 38(10): 2069-2074.

参考文献

［1］杨永平. 发动机台架实验中喷油器针阀升程的调节方法及应用[J]. 小型内燃机与摩托车, 2006, 35(3):8-10.
YANG Yong-ping. Method and application of adjusting the needle valve lift in engine performance test[J]. Small Internal Combustion Engine and Motorcycle, 2006, 35(3):8-10.(in Chinese)
[2] 夏尚飞, 王会明, 侯加林. 喷油器针阀升程自动测试系统的研究[J]. 拖拉机与农用运输车, 2007, 34(5):73-75, 77.
XIA Shang-fei, WANG Hui-ming, HOU Jia-lin. Research onautomatic testing system of injector nozzle body[J]. Tractor & Farm Transporter, 2007, 34(5):73-75, 77.(in Chinese)

[3] Payri R, Gimeno J, Viera J P, et al. Needle lift profile influence on the vapor phase penetration for a prototype diesel direct acting piezoelectric injector[J]. Fuel, 2013, 113(2):257-265.
[4] 陈威, 袁留杰, 胡以怀. 伞喷喷嘴针阀升程对燃油流动及空化的影响[J]. 内燃机工程, 2016, 37(4):206-213.
CHEN Wei, YUAN Liu-jie, HU Yi-huai. Investigation of influence of needle lift on internal flow and cavitation phenomenon in a conical-spray nozzle[J]. Chinese Internal Combustion Engine Engineering, 2016, 37(4):206-213.(in Chinese)
[5] 解方喜, 姚卓彤, 胡雪松, 等. 针阀运动和油压波动对燃油喷雾特性的影响[J]. 吉林大学学报:工学版, 2013, 43(4):897- 902.
XIE Fang-xi, YAO Zhuo-tong,HU Xue-song, et al. Influence of dynamic change of needle and hydraulic pressure in diesel injection nozzle on fule spray characteristic[J]. Journal of Jilin University:Engineering and Technology Edition, 2013, 43(4):897-902.(in Chinese)
[6] Lino P, Maione G, Saponaro F, et al. Evolutionary optimization of model parameters for electro-injectors in common rail diesel engines[J]. Journal of Dynamic Systems Measurement and Control, 2016, 138(4):041001-1-041001-8.
[7] 苏海峰, 张幽彤, 王尚勇, 等. 高压共轨喷油器喷射特性试验与仿真[J]. 农业机械学报, 2011, 42(1):22-26, 30.
SU Hai-feng, ZHANG You-tong, WANG Shang-yong, et al. Numerical-experimental investigation of injection characteristics of high pressure common rail injector[J]. Transactions of the Chinese Society for Agricultural Machinery, 2011, 42(1):22-26, 30.(in Chinese)
[8] Qiu T, Song X, Lei Y, et al. Influence of inlet pressure on cavitation flow in diesel nozzle[J]. Applied Thermal Engineering, 2016, 109:364-372.

第38卷
第10期2017 年10月兵工学报ACTA
ARMAMENTARIIVol.38No.10Oct.2017

[1]	李子铭, 刘振明, 刘景斌, 陈萍. 舰船柴油机微通道内燃油空化现象的模型对比[J]. 兵工学报, 2023, 44(10): 3091-3100.
[2]	黎一锴，彭靖，史中杰，檀丽宏，李耀宗. 具有环境适应性的柴油机最小压缩比设计方法[J]. 兵工学报, 2022, 43(8): 1744-1752.
[3]	郭圣刚，王建平，赵忠诚，程晶晶，田新伟. 金属掺杂对高强化柴油机活塞销类金刚石薄膜涂层摩擦学性能的影响[J]. 兵工学报, 2021, 42(4): 715-722.
[4]	于飞，刘波澜，颜超，韩耀辉，王文泰. 柴油机电动可变气门正时机构特性[J]. 兵工学报, 2021, 42(3): 468-477.
[5]	顾程，乔新勇，韩立军. 不同燃油对某重型柴油机燃烧稳定性影响分析[J]. 兵工学报, 2020, 41(3): 426-433.
[6]	强永平，李海鹰，张晓琴，蔡忠周，朱伟青，李玉峰，龚永星. 柴油机回水温度对燃烧过程影响试验研究[J]. 兵工学报, 2020, 41(2): 222-230.
[7]	赵建华，应宇辰，郭成豹. 柴油机磁场的计算、试验与消磁优化[J]. 兵工学报, 2020, 41(2): 350-355.
[8]	李佳蔚，崔涛，刘宇航，师帅楠，孙强. 基于排气温度动态模型的在线观测器研究[J]. 兵工学报, 2019, 40(8): 1562-1571.
[9]	王子玉，张岩，王雷，刘金龙，白洪林，李玉峰. 进气门晚关米勒循环对高强化柴油机燃烧和换气影响的研究[J]. 兵工学报, 2019, 40(1): 8-17.
[10]	王旭东，熊春华，鲁长波，安高军，王锋. 高原环境下柴油机燃用聚醚型含氧燃料热平衡试验研究[J]. 兵工学报, 2018, 39(8): 1473-1478.
[11]	刘永丰，王龙飞，刘胜，尹玉婷，杨震寰. 海拔高度对柴油机缸内热流分布影响规律研究[J]. 兵工学报, 2018, 39(6): 1049-1057.
[12]	刘宇航，张付军，高宏力，王苏飞. 对置活塞二冲程柴油机新鲜充量短路研究[J]. 兵工学报, 2018, 39(6): 1058-1065.
[13]	刘宇航，张付军，慕连好，高宏力，王苏飞. 对置活塞二冲程柴油机换气子阶段完成比例研究[J]. 兵工学报, 2018, 39(3): 428-435.
[14]	谭丕强，王德源，王成官，李远，楼狄明，李云广，刘胜，杨振寰. 高原环境下重型柴油机的性能优化研究[J]. 兵工学报, 2018, 39(3): 436-443.
[15]	赵文柱，王宪成，赵永东，孙志新，徐冬冬. 耦合内部流动的喷孔积碳对柴油机喷雾影响研究[J]. 兵工学报, 2018, 39(2): 217-223.

高压共轨喷油器针阀开启与关闭过程规律研究

Research on Movement Characteristics of Needle Valve in Common Rail Injector for Diesel Engine

PDF

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价