多管火箭武器箱式复合材料定向器长期堆码贮存吸湿-蠕变耦合行为预测

doi:10.3969/j.issn.1000-1093.2021.03.005

摘要/Abstract

摘要： 为研究多管火箭武器箱式复合材料定向器长期堆码贮存吸湿-蠕变耦合行为，在Schapery非线性模型中引入湿移位因子，推导考虑吸湿效应的三维正交各向异性非线性蠕变本构模型。制备E-玻璃纤维/6509环氧树脂复合材料层压板，开展吸湿试验、静态力学性能试验和短期蠕变-回复试验，获得复合材料吸湿特性参数和吸湿率、应力相关非线性蠕变参数。采用有限元方法建立湿扩散-非线性蠕变耦合数值分析模型，预测箱式复合材料定向器贮存15 a后的蠕变变形。结果表明：在一般条件军用仓库中，贮存1 a时间后水分扩散到定向器内表面，贮存8 a后定向器基本达到饱和吸湿状态；所有20根定向器的最大残余变形位置都位于第2、3定位安装环之间，并且在三维空间内近似呈马鞍状分布；上下两行中间位置定向器的残余变形最大，最大值为0.38 mm；左右两列中间位置定向器的残余变形最小，最小值为0.33 mm.

关键词: 多管火箭武器, 复合材料定向器, 堆码贮存, 非线性黏弹性, 吸湿-蠕变耦合

Abstract: In order to investigate the moisture absorption-creep coupling behavior during long-term stacking storage of box-type composite directors for multiple launch rocket systems, a three-dimensional orthotropic nonlinear creep constitutive model considering moisture effect is derived by introducing the moisture shift factor into the Schapery's nonlinear equation. The E-fiberglass/6509 epoxy resin composite laminates were prepared, and the moisture absorption test, static mechanical performance test and short-term creep-recovery test were carried out to obtain the hygroscopic parameters and the moisture- and stress-dependent nonlinear creep parameters. Finite element method was used to establish a numerical model of coupled moisture diffusion-nonlinear creep analysis. The creep deformation of composite directors after 15 years of storage was predicted. The calculated results show that the moisture diffuses to the inner surface of director after one year of storage in the general military warehouse and reaches the quasi-equilibrium uptake state after eight years. The maximum residual deformations of all 20 directors take place between the second and third positioning rings, and are approximately distributed in a saddle shape in three-dimensional space. The residual deformations of the directors between upper and lower rows are the largest with a maximum value of 0.38 mm, while those of the directors between left and right columns are the smallest with a minimum value of 0.33 mm.

Key words: multiplelaunchrocketsystem, compositedirector, stackingstorage, nonlinearviscoelasticity, moistureabsorption-creepcoupling

中图分类号:

孙同生，朱隽垚，于存贵，杨文超，徐强. 多管火箭武器箱式复合材料定向器长期堆码贮存吸湿-蠕变耦合行为预测[J]. 兵工学报, 2021, 42(3): 487-498.

SUN Tongsheng, ZHU Junyao, YU Cungui, YANG Wenchao, XU Qiang. Prediction of Moisture Absorption-creep Coupling Behavior of Box-type Composite Directors for Multiple Launch Rocket System under Long-term Stacking Storage[J]. Acta Armamentarii, 2021, 42(3): 487-498.

参考文献

［1］李彬,庞永杰,朱枭猛,等.水下航行器环肋复合材料耐压壳6σ优化设计[J].兵工学报, 2018, 39(6):1171-1177.
LI B, PANG Y J, ZHU X M, et al. 6σ optimization design of ring-stiffened composite pressure hull of underwater vehicle[J].Acta Armamentarii,2018, 39(6):1171-1177.(in Chinese)
[2］代礼葵,孙耀宁,王国建.玻璃纤维/环氧乙烯基酯树脂复合材料环境综合因素下的冲蚀行为及机制[J].复合材料学报,2019,36(9):2059-2066.
DAI L K,SUN Y N,WANG G J.Erosion behavior and mechanism of glass fiber/epoxy vinlester composites under multiple environmental factors[J]. Acta Materiae Compositae Sinica,2019, 36(9): 2059-2066.(in Chinese)
[3］ TUTTLE M E,BRINSON H F.Prediction of the long-term creep compliance of general composite laminates[J]. Experimental Mechanics,1986, 26(1):89-102.
[4］马少华,王勇刚,回丽,等.湿热环境对碳纤维环氧树脂复合材料弯曲性能的影响[J].材料工程,2016, 44(2):81-87.
MA S H,WANG Y G,HUI L,et al.Influence of hygrothermal environment on flexural property of carbon fiber epoxy composite[J].Journal of Materials Engineering,2016,44(2):81-87.(in Chinese)
[5］冯振宇,解江,迟琪琳,等.湿热环境对复合材料单向板拉伸性能的影响[J].高分子材料科学与工程,2018, 34(11):41-47.
FENG Z Y，XIE J, CHI Q L,et al.Influence of hygrothermal environment on tensile property of unidirectional composite laminates[J].Polymer Materials Science and Engineering,2018, 34(11):41-47. (in Chinese)
[6］徐伟伟,文友谊,顾轶卓,等.航空用国产碳纤维/双马树脂复合材料湿热特性[J].北京航空航天大学学报,2020, 46(1):86-94.
XU W W,WEN Y Y,GU Y Z,et al. Hygrothermal property of domestic carbon/ bismaleimide resin composites for aeronautic application[J].Journal of Beijing University of Aeronautics and Astronautics, 2020, 46(1):86-94. (in Chinese)
[7］ JURF R A,VINSON J R.Effect of moisture on the static and viscoelastic shear properties of epoxy adhesives[J].Journal of Materials Science, 1985,20(8):2979-2989.
[8］刘建华,赵亮,李松梅,等.盐雾环境对玻璃纤维增强树脂基复合材料力学性能的影响[J].复合材料学报,2007, 24(3):18-22.
LIU J H, ZHAO L, LI S M, et al. Effect of salt spray on mecha- nical properties of glass fiber reinforced polymer composites[J]. Acta Materiae Compositae Sinica, 2007, 24(3):18-22. (in Chinese)
[9］ HADDAR N, KSOURI I, KALLEL T, et al. Effect of hygrothermal ageing on the monotonic and cyclic loading of glass fiber reinforced polyamide[J]. Polymer Composites, 2014, 35(3):501-508.
[10］许家宝,周储伟.玻璃/亚麻纤维混杂复合材料的吸湿和动态粘弹性性能研究[J].玻璃钢/复合材料, 2019(5):38-43.
XU J B,ZHOU C W.Study on moisture absorption and dynamic viscoelasticity of glass/flax fiber hybrid composites[J].Fiber Reinforced Plastics/Composites, 2019(5):38-43.(in Chinese)
[11］高禹,李晨浩,王进,等.湿热环境作用下HT280双马来酰亚胺树脂的蠕变性能与模型[J].高分子材料科学与工程, 2020, 36(2):74-81.
GAO Y，LI C H,WANG J,et al.Creep properties and model of HT280 bismaleimide resin in hygrothermal environment[J].Polymer Materials Science and Engineering, 2020, 36(2):74-81. (in Chinese)
[12］ KONTAXIS L C, GEORGALI A, PORTAN D V, et al.Flexural creep behavior of epoxy/cotton composite materials before and after saline absorption for orthopedics applications[J]. AIP Conference Proceedings,2018, 1932(1): 030044.
[13］ WANG A S D,LIU P K.Humidity effects on the creep behavior of an epoxy-graphite composite[J].Journal of Aircraft, 1977, 14(4): 383-386.
[14］ GUEDES R M,S A,FARIA H.Influence of moisture absorption on creep of GRP composite pipes[J]. Polymer Testing, 2007,26(5): 595-605.
[15］ CHENG X Q,LIU S F,ZHANG J K,et al.Hygrothermal effects on mechanical behavior of scarf repaired carbon-epoxy laminates subject to axial compression loads: experiment and numerical simulation[J]. Polymer Composites,2018,39(3):904-914.
[16］张婕,程小全,程羽佳,等.湿热环境对CCF800/环氧挖补板拉压性能的影响[J].北京航空航天大学学报, 2020, 46(6): 1116-1124.
ZHANG J,CHENG X Q,CHENG Y J,et al.Effect of hygrothermal environment on tensile and compressive properties of CCF800/epoxy scarf-repaired laminates[J]. Journal of Beijing University of Aeronautics and Astronautics, 2020, 46(6):1116- 1124. (in Chinese)
[17］韩啸.胶接接头湿热环境耐久性试验与建模研究[D].大连：大连理工大学, 2014.
HAN X. Experimental andmodeling study on the durability performance of adhesively bonded joint in hygro-thermal environment[D].Dalian：Dalian University of Technology, 2014. (in Chinese)
[18］ SCHAPERY R A.On the characterization of a nonlinear fiber-reinforced plastic[J].Polymer Engineering and Science,1969,9(4): 295-310.
[19］ SCHAPERY R A.An engineering theory of nonlinear viscoelasti- city with applications[J]. International Journal of Solids and Structures, 1966,2(3):407-425.
[20］ KENNEDY T C,WANG M.Three-dimensional, nonlinear visco- elastic analysis of laminated composites[J]. Journal of Composite Materials, 1994, 28(10):902-925.
[21］ American Society of Testing Materials International. Standard test method for moisture absorption properties and equilibrium conditioning of polymer matrix composite materials: ASTM D5229/D5229M-2014[S]. West Conshohocken，PA，US: ASTM Committee, 2014.
[22］中国人民解放军总装备部.军用物资贮存环境条件:GJB 2770-96[S].北京:国防科学技术工业委员会,1996.
General Armament Department of PLA. Storage environmental condition for military material: GJB 2770-96[S].Beijing:Commission of Science, Technology and Industry for National Defence,1996. (in Chinese)
[23］ American Society of Testing Materials International. Standard test method for tensile properties of polymer matrix composite materials: ASTM D3039/D3039M-2014[S]. West Conshohocken，PA，US: ASTM Committee, 2014.
[24］ American Society of Testing Materials International. Standard test method for in-plane shear response of polymer matrix composite materials by tensile test of a ±45° laminates: ASTM D3518/D3518M-2013[S].West Conshohocken，PA，US: ASTM Committee, 2013.
[25］ Japanese Standards Association. Testing methods for tensile creep of carbon fiber reinforced plastics: JIS K 7078-1996[S]. Tokyo，Japan: Japanese Standards Association, 1996.
[26］孙同生, 于存贵, 杨文超, 等.湿热与拉伸载荷耦合作用下玻纤/环氧复合材料的吸湿特性[J].复合材料科学与工程,2020(5):25-31.
SUN T S, YU C G, YANG W C, et al. The combined effects of hygrothermal and external load on the moisture absorption beha- vior of E-glass/epoxy composites[J].Composites Science and Engineering, 2020(5):25-31. (in Chinese)
[27］ GUEDES R M. Creep and fatigue in polymer matrix composites[M].Cambridge,UK:Woodhead Publishing Limited, 2011:11-13.
[28］ YU C G,SUN T S, XIAO G Y.Study on creep performance of launch canister under long-term storage[J].Transactions of the Canadian Society for Mechanical Engineering,2018,43(2):199-208.

[1]	徐萧，高世桥，牛少华，申丽，刘海鹏，欧卓成. 灌封材料对侵彻过载下弹载器件的防护分析[J]. 兵工学报, 2017, 38(7): 1289-1300.
[2]	杨树兴. 陆军多管火箭武器的发展与思考[J]. 兵工学报, 2016, 37(7): 1299-1305.