串联电池组的母线式电压采集系统优化设计

doi:10.3969/j.issn.1000-1093.2014.05.001

兵工学报 ›› 2014, Vol. 35 ›› Issue (5): 577-582.doi: 10.3969/j.issn.1000-1093.2014.05.001

• 论文 • 下一篇

串联电池组的母线式电压采集系统优化设计

马晓军，可荣硕，魏曙光，项宇，曾庆含

（装甲兵工程学院控制工程系，北京 100072）

收稿日期:2013-08-19 修回日期:2013-08-19 上线日期:2014-06-23
作者简介:马晓军(1963—)男，教授，博士生导师
基金资助:
武器装备预先研究项目（2011YY25）

Optimal Design of Bus-type Voltage Acquisition System

MA Xiao-jun, KE Rong-shuo, WEI Shu-guang, XIANG Yu, ZENG Qing-han

（Department of Control Engineering， Academy of Armored Force Engineering， Beijing 100072， China）

Received:2013-08-19 Revised:2013-08-19 Online:2014-06-23

摘要/Abstract

摘要： 动力电池组、燃料电池等通常采用多路串联式供电结构，单体电压参数为反映电池性能的重要指标。设计了一种母线式电压采集系统，该系统利用光控继电器把电池单体加载到测量母线，通过移位寄存器74HC164逻辑控制实现电池单体电压巡检，经过一套信号调理、隔离电路处理，使整体测量一致性提高，相比于采用译码器的逻辑电路，从元件数量和控制程序上都得到优化。集成PIC18F2580最小系统及CAN总线接口，实现模块化及可扩展性。实验结果表明：该采集系统性能稳定，满足测量精度要求，并成功应用于3 kW和10 kW燃料电池系统。

关键词: 电气工程, 动力电池组, 燃料电池, 测量母线, 电压采集, 动态加载

Abstract: Power supply system, such as power battery pack and fuel cell,normally uses a series-type power supply structure, and the voltage parameter of battery is an important performance index of the battery. A bus-type voltage acquisition system is designed. In the system, the photoelectric relay is adopted to load a battery on the measurement bus, and the voltage monitoring is implemented by means of the logic control of shift register 74HC164. Thus the consistency of the overall measurement is improved through single signal processing and isolation circuit. The number of components is reduced, and the circuit structure and control procedure are optimized compared to logic circuit with decoder. The modularization and scalability of the measurement system are achieved by PIC18F2580 minimum system and CAN bus interface. The experimental result shows that the system has stable performance and meets the requirement of measuring accuracy, which has been used for the voltage monitoring of 3 kW and 10 kW fuel cells.

Key words: electrical engineering, power battery pack, fuel cell, measurement bus, voltage acquisition, dynamic loading

中图分类号:

TM912.2

马晓军，可荣硕，魏曙光，项宇，曾庆含. 串联电池组的母线式电压采集系统优化设计[J]. 兵工学报, 2014, 35(5): 577-582.

MA Xiao-jun, KE Rong-shuo, WEI Shu-guang, XIANG Yu, ZENG Qing-han. Optimal Design of Bus-type Voltage Acquisition System[J]. Acta Armamentarii, 2014, 35(5): 577-582.

参考文献

［1］李顶根,李竟成,李建林. 电动汽车锂电池能量管理系统研究[J].仪器仪表学报,2007,28(8):1522-1527.
LI Ding-gen, LI Jing-cheng, LI Jian-lin. Research of electric vehicle Li-ion battery energy management system[J].Chinese Journal of Scientific Instrument, 2007,28(8):1522-1527. (in Chinese)
[2] 刘旭,白焰,刘鹤.质子交换膜燃料电池系统的控制策略综述[J].化工自动化及仪表，2012,39(4):439-443.
LIU Xu, BAI Yan, LIU He. Summarization of control strategy for proton exchange membrane fuel cells[J].Control and Instruments in Chemical Industry, 2012,39(4):439-443. (in Chinese)
[3] 马晓军,可荣硕,许世蒙，等.质子交换膜燃料电池系统动态控制研究[J].兵工学报,2012,33(12): 1409-1415.
MA Xiao-jun, KE Rong-shuo, XU Shi-meng, et al. Research on dynamic control of proton exchange membrane fuel cell system[J]. Acta Armamentarii, 2012,33(12):1409-1415. (in chinese)
[4] 李树靖,林凌,李刚.串联电池组电池电压测量方法的研究[J].仪器仪表学报,2003,24(9):213-215.
LI Shu-jing, LIN Ling, LI Gang. Research on methods of measuring voltage in a serial battery cluster[J]. Chinese Journal of Scientific Instrument,2003,24(9):213-215. (in Chinese)
[5] Yang S, He L P, Zhong Z H. A battery monitoring system based on CAN bus for electric vehicles[J]. Journal of Guizhou University of Technology, 2004,33(2):90-95.
[6] 卫东,郑东,褚磊民.燃料电池单电池电压检测系统设计[J].电源技术,2010,34(7):658-660.
WEI Dong, ZHENG Dong, CHU Lei-min. Design of cell voltage detection system for fuel cells[J].Chinese Journal of Power Sources,2010,34(7):658-660. (in Chinese)
[7] 张彩萍,张承宁,李军求.电动车辆动力电池组电压采集电路设计[J].电气应用,2007,26(12):91-93.
ZHANG Cai-ping, ZHANG Cheng-ning, LI Jun-qiu. Design of voltage collecting circuit for traction battery pack on electric vehicle[J]. Electrotechnical Application, 2007,26(12):91-93. (in Chinese)
[8] Burns C E. Battery management system and method: US, 6983212[P].2006-01-03.
[9] 杨虎,杜常清,颜伏伍，等.高精度动力电池组电压采集单元的设计[J].电源技术,2011,35(10):1221-1226.
YANG Hu, DU Chang-qing, YAN Fu-wu, et al. Design of an accurate voltage detecting unit for power batteries pack[J]. Chinese Journal of Power Sources,2011,35(10): 1221-1226. (in Chinese)
[10] 吴骞,许家群,夏文川，等.基于光电隔离继电器的燃料电池堆单片电压检测系统的设计[J].自动化与仪器仪表,2005（7）:38-39.
WU Qian, XU Jia-qun, XIA Wen-chuan, et al. Single cell’s voltage measurement system designed for fuel cell stack[J]. Application of Electronic Technique,2005(7）：38-39. (in Chinese)

[1]	赵精晶，石庚辰，杜琳. 盘式永磁微型发电机的磁路设计方法[J]. 兵工学报, 2014, 35(8): 1144-1151.
[2]	解璞，赵锦成，王川川，王勇. 军用电站电缆雷电感应过电压影响因素研究[J]. 兵工学报, 2014, 35(2): 214-219.
[3]	项宇，马晓军，刘春光，可荣硕，赵梓旭. 基于改进的粒子群优化扩展卡尔曼滤波算法的锂电池模型参数辨识与荷电状态估计[J]. 兵工学报, 2014, 35(10): 1659-1666.
[4]	张中华, 袁惠群, 张宇白. 一类电机系统的分岔分析与 Hopf 分岔控制[J]. 兵工学报, 2013, 34(8): 1051-1056.
[5]	史婷娜, 张茜, 肖有文, 夏长亮. 无刷直流电机反电势滑模观测及参数在线辨识[J]. 兵工学报, 2013, 34(6): 739-747.
[6]	赵付舟, 王俊席, 崔教林, 汪秀敏. 汽车尾气废热回收的热电模块布置特性研究[J]. 兵工学报, 2013, 34(5): 634-638.
[7]	郭成豹, 刘大明. 薄钢壳物体磁特征建模研究[J]. 兵工学报, 2012, 33(8): 912-915.
[8]	罗宏浩，廖自力. 基于神经网络的内置式永磁电动机弱磁区最佳电流相位曲线拟合[J]. 兵工学报, 2012, 33(7): 870-874.
[9]	罗宏浩，王福兴. 永磁电动机绕组换接的性能分析与切换电路研究[J]. 兵工学报, 2012, 33(7): 804-809.
[10]	颜南明，张豫南，王和源，胡国庆. 新型电传动车辆驱动控制系统设计[J]. 兵工学报, 2012, 33(2): 232-236.
[11]	马晓军, 可荣硕, 许世蒙, 闫之峰, 袁东. 质子交换膜燃料电池系统动态控制研究[J]. 兵工学报, 2012, 33(12): 1409-1415.

串联电池组的母线式电压采集系统优化设计

Optimal Design of Bus-type Voltage Acquisition System

PDF

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 11

编辑推荐

Metrics

本文评价