全程转速下浮动支撑湿式离合器带排转矩计算模型与验证

doi:10.3969/j.issn.1000-1093.2018.09.001

兵工学报 ›› 2018, Vol. 39 ›› Issue (9): 1665-1674.doi: 10.3969/j.issn.1000-1093.2018.09.001

全程转速下浮动支撑湿式离合器带排转矩计算模型与验证

师路骐¹，马彪^1，2，李和言^1，2，吴俊峰¹，李慧珠¹，颜旭¹，常富祥¹

(1.北京理工大学机械与车辆学院，北京 100081；2.北京电动车辆协同创新中心，北京 100081)

收稿日期:2018-01-17 修回日期:2018-01-17 上线日期:2018-10-25
通讯作者: 李和言（1978—），男，副教授，硕士生导师 E-mail:lovheyan@bit.edu.cn
作者简介:师路骐（1992—），男，硕士研究生。E-mail：luqi_shi@163.com
基金资助:
国家自然科学基金项目(51775045)；工业与信息化部基础产品创新科研项目(VTDP3203)

Modeling and Experimental Validation of Drag Torque of Wet Multi-disk Clutch with Spline Connected Restriction in Full SpeedRange

SHI Lu-qi¹， MA Biao^1，2， LI He-yan^1，2， WU Jun-feng¹， LI Hui-zhu¹， YAN Xu¹， CHANG Fu-xiang¹

(1.School of Mechanical Engineering， Beijing Institute of Technology， Beijing 100081， China；2.Collaborative Innovation Center for Electric Vehicle in Beijing， Beijing 100081， China)

Received:2018-01-17 Revised:2018-01-17 Online:2018-10-25

摘要/Abstract

摘要： 基于摩擦元件偏置现象及高转速差下间隙收缩现象，运用陀螺效应原理建立了摩擦元件低转速差下偏置状态分析模型。针对摩擦副间油膜的高速负压现象，建立了高转速差下摩擦副间隙负压收缩模型，分析了从低速差到高速差全程变化过程下的摩擦副间隙动态变化规律。提出考虑摩擦副间隙动态变化影响的带排转矩改进模型，进行了仿真分析，并搭建了带排转矩试验平台。研究结果表明：润滑条件一定时，湿式多片离合器带排转矩随转速差增大呈先增大、后减小、再增大的变化趋势；摩擦副偏置现象在低转速差(0~1 000 r/min)段对带排转矩影响较大，而间隙收缩现象在中转速差和高转速差(大于1 000 r/min)段时为影响带排转矩的主要因素；通过与试验结果对比发现摩擦副间隙动态变化影响的改进模型平均相对误差在中转速差和高转速差(大于1 000 r/min) 段时为6.34%，显著提高了对湿式多片离合器带排转矩值估算的准确度。

关键词: 湿式离合器, 带排转矩, 摩擦副元件偏置, 摩擦副间隙收缩

Abstract: A theoretical model is established for the analysis of offset state of friction elements under the condition of low speed difference based on the gyro effect. As for the gap shrinkage under the condition of high speed difference, a negative pressure contraction model for friction pairs is built by analyzing the oil film and the pressure on friction plates. The dynamic change of gap between the friction pairs in the whole variation range of the relative speed is then investigated. Finally, an improved model, considering the influence of dynamic change of gap between the friction pairs, is proposed to study the drag torque. The simulated and test results indicate that, under the condition of the same lubrication, the drag torque of the wet multi-plate clutch increases first and then decreases and finally increases with the rise of the rotational speed difference. The main factors influencing the drag torque are the offset of friction plate under the condition of the low speed difference (0-1 000 r/min), and the gap shrinkages under the condition of the middle and high speed differences (>1 000 r/min). Through the comparison of test results and the simulated results obtained from the improved model, the average relative error is only 6.34% under the condition of medium and high speed differences (>1 000 r/min), which can greatly improve the estimation accuracy of drag torque of wet multi-plate clutch.Key

Key words: wetclutch, dragtorque, frictionpairoffset, frictionpairgapshrinkage

中图分类号:

TJ810.3⁺21

师路骐，马彪，李和言，吴俊峰，李慧珠，颜旭，常富祥. 全程转速下浮动支撑湿式离合器带排转矩计算模型与验证[J]. 兵工学报, 2018, 39(9): 1665-1674.

SHI Lu-qi， MA Biao， LI He-yan， WU Jun-feng， LI Hui-zhu， YAN Xu， CHANG Fu-xiang. Modeling and Experimental Validation of Drag Torque of Wet Multi-disk Clutch with Spline Connected Restriction in Full SpeedRange[J]. Acta Armamentarii, 2018, 39(9): 1665-1674.

参考文献

［1］ Lloyd F A. Parameters contributing to power loss in disengaged wet clutches[C]∥SAE International Off-Highway and Powerplant Congress and Exposition.Warrendale, PA, US: Society of Automotive Engineers,1974:740694.
[2］ Kato Y, Murasugi T, Hirano H, et al. Fuel economy improvement through tribological analysis of the wet clutches and brakes of an automatic transmission[C]∥Proceedings of JSAE convention proceedings. Tokyo，Japan：Society of Automotive Engineers of Japan,1993:57-60.
[3］ Hashimoto H, Wada S, Murayama Y. The performance of a turbulent-lubricated sliding bearing subject to centrifugal effect[J].Transactions of the Japan Society of Mechanical Engineers Series C, 1984, 49(446):1753-1761.
[4］ Yuan Y, Liu E A, Hill J, et al. An improved hydrodynamic model for open wet transmission clutches[J].ASME Journal of Fluids Engineering, 2007, 129(3): 333-337.
[5］ Walker P D, Zhang N, Tamba R, et al. Simulations of drag torque affecting synchronisers in a dual clutch transmission[J]. Japan Journal of Industrial and Applied Mathematics, 2011, 28(1): 119-140.
[6］马彪. 履带车辆综合传动特性的动态仿真研究[D]. 北京: 北京理工大学, 1999.
MA Biao. Study on the dynamic simulation of integrated transmission characteristics of tracked vehicles[D]. Beijing: Beijing Institute of Technology, 1999.（in Chinese）
[7］张志刚,周晓军,李永军,等. 湿式多片换档离合器带排转矩的预测模型[J]. 浙江大学学报：工学版，2011,45(4):708-713.
ZHANG Zhi-gang, ZHOU Xiao-jun, LI Yong-jun，et al. Drag torque prediction model of wet multi-disk shifting clutch[J]. Journal of Zhejiang University：Engineering Science, 2011, 45(4): 708-713. （in Chinese）
[8］ Yuan S H, Peng Z X, Jing C. Experimental research and mathematical model of drag torque in single-plate wet clutch[J]. Chinese Journal of Mechanical Engineering, 2011, 24(1):91-97.
[9］项昌乐,章颖莹,刘辉. 高转速差车用湿式离合器带排转矩特性研究[J]. 机械工程学报,2013,49(20):71-77.
XIANG Chang-le, ZHANG Ying-ying, LIU Hui. Research on drag torque of high relative speed open wet clutch of vehicle[J]. Journal of Mechanical Engineering, 2013, 49(20): 71-77.（in Chinese）

[10］杨立昆,李和言,马彪.改进的湿式离合器带排转矩模型[J].吉林大学学报：工学版，2014,44(5):1270-1275.
YANG Li-kun, LI He-yan, MA Biao. Improved drag torque model for wet clutch[J]. Journal of Jilin University：Engineering and Technology Edition，2014,44(5): 1270-1275. （in Chinese）
[11］景琦. 湿式换挡离合器带排损失特性研究[D]. 北京: 北京理工大学, 2012.
JING Qi. Study on the drag loss characteristic of wet shifting clutch[D]. Beijing: Beijing Institute of Technology, 2012. （in Chinese）
[12］刘继凯，马彪，李和言. 摩擦片表面沟槽对离合器带排转矩的影响[J]. 华中科技大学学报：自然科学版，2015,43(2): 35-39.
LIU Ji-kai, MA Biao, LI He-yan. Influence of surface grooves on friction plate on drag torque of wet clutch[J]. Journal of Huazhong University of Science and Technology：Natural Science Edition，2015,43(2): 35-39. （in Chinese）
[13］张昌芳，刘家福. 抖空竹的力学原理分析[J]. 力学与实践，2006,28(4): 89-92.
ZHANG Chang-fang, LIU Jia-fu. Analysis of mechanical principles of shaking diabolo[J]. Mechanics in Engineering, 2006,28(4): 89-92. （in Chinese）
[14］ Li H Y, Jing Q，Ma B. Modeling and parametric study on drag torque of wet clutch[C]∥ Proceedings of the FISITA 2012 World Automotive Congress. Berlin, Germany:Springer,2013:21-30.
[15］罗灯明，郑长松，侯树梅，等. 湿式换挡离合器全油膜状态下带排损失研究[J]. 汽车技术，2013(4): 30-34.
LUO Deng-ming, ZHENG Chang-song, HOU Shu-mei，et al. Research on drag loss of wet shifting clutch under full oil film condition[J]. Automobile Technology，2013(4): 30-34. （in Chinese）
[16］赵二辉，马彪，李和言，等. 转速对湿式离合器局部润滑及摩擦特性影响研究[J]. 兵工学报，2017,38(4): 625-633.
ZHAO Er-hui,MA Biao, LI He-yan, et al. Influence of rotating speed on local lubrication and friction characteristics of wet clutch[J]. Acta Armamentarii, 2017,38(4): 625-633. （in Chinese）
[17］ Hu J B, Peng Z X，Yuan S H. Drag torque prediction model for the wet clutches[J]. Chinese Journal of Mechanical Engineering，2009，22(2): 238-243.

第39卷
第9期2018 年9月兵工学报ACTA
ARMAMENTARIIVol.39No.9Sep.2018

[1]	张琳，魏超，胡纪滨，胡琦. 车用空载湿式离合器高速碰撞摩擦特性及带排转矩分析[J]. 兵工学报, 2020, 41(7): 1270-1279.
[2]	成宵，朱茂桃，田乃利. 油相-气相两相流对湿式离合器带排转矩影响的数值分析[J]. 兵工学报, 2020, 41(5): 850-857.
[3]	娄伟鹏，郑长松，李和言，陈建文，张周立，马源. 高速《Symbol》v湿式换挡离合器排油阀临界开启和关闭压力研究[J]. 兵工学报, 2017, 38(9): 1665-1672.
[4]	赵二辉，马彪，李和言，杜秋，李慧珠，马成男. 转速对湿式离合器局部润滑及摩擦特性影响研究[J]. 兵工学报, 2017, 38(4): 625-633.
[5]	马彪，陈飞，李和言，熊涔博，王宇森，李耿标. 湿式离合器摩擦副平均温升特性研究[J]. 兵工学报, 2016, 37(6): 961-968.

全程转速下浮动支撑湿式离合器带排转矩计算模型与验证

Modeling and Experimental Validation of Drag Torque of Wet Multi-disk Clutch with Spline Connected Restriction in Full SpeedRange

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 5

编辑推荐

Metrics

本文评价