同心筒发射燃气流二次燃烧数值研究及导流板结构改进

doi:10.3969/j.issn.1000-1093.2014.01.009

兵工学报 ›› 2014, Vol. 35 ›› Issue (1): 62-69.doi: 10.3969/j.issn.1000-1093.2014.01.009

同心筒发射燃气流二次燃烧数值研究及导流板结构改进

胡晓磊，乐贵高，马大为，朱忠领

（南京理工大学机械工程学院，江苏南京 210094)

收稿日期:2013-04-23 修回日期:2013-04-23 上线日期:2014-03-18
作者简介:胡晓磊（1987—），男，博士研究生
基金资助:
国防预先研究项目（403050102）

Numerical Simulation of Secondary Combustion Gas Field in Concentric Canister Launcher and Improvement Measures of Guider

HU Xiao-lei, LE Gui-gao, MA Da-wei, ZHU Zhong-ling

(School of Mechanical Engineering, Nanjing University of Science and Technology, Nanjing 210094, Jiangsu, China)

Received:2013-04-23 Revised:2013-04-23 Online:2014-03-18

摘要/Abstract

摘要： 针对同心筒热发射燃气射流二次燃烧冲击效应问题，采用3阶精度的MUSCL格式求解11组分12步基元化学反应动力学模型，弹体运动运用域动分层网格更新方法，数值模拟了同心筒发射H₂/CO混合燃气流场。在燃气自由射流二次燃烧数值模拟结果与文献实验数据对比验证的基础上，分析了同心筒发射燃气流含化学反应的流动特点，以及在导弹出筒时筒口导流板结构对弹体的影响。数值结果表明：在筒外燃气与空气混合区域出现明显的二次燃烧，而在筒内二次燃烧几乎可以忽略；当弹底出筒后，从内外筒间隙排除的燃气、导弹尾部燃气射流和弹底之间相互干扰，形成反溅激波；反应流流场轴线温度高于冻结流和单一组分流流场轴线温度；导流板结构能明显降低弹体表面温度，其高度最优值在1.5倍内外筒间隙附近。研究结果对同心筒发射装置结构优化设计具有一定理论参考意义。

关键词: 液体力学, 同心筒热发射, 二次燃烧, 域动分层网格, 导流板

Abstract: To study the thermo-impact of jet flow secondary combustion, a three-order accurate MUSCL scheme is employed to solve 12-step reaction and 11 species chemical reactions of H₂/CO mixed combustion gas field in concentric canister launcher(CCL), and the zone moving and dynamically layering methods are adopted to simulate missile motion. Compared with free-jet flow experimental results, it is shown that the method is feasible. The jet field characteristic with chemical reactions and the temperature changes of missile body are analyzed. The results show that chemical reaction occures in mixing layer of gas and air out of cylinder and there is no reaction in CCL tube. Reflective shock is due to the mutual interference of gas out of cylinder, exhaust plume and missile tail. The axial temperature of reaction flow field is higher than those of frozen flow and single component flow. Guider can reduce missile body temperature and its height optimal value is near 1.5 times the clearances inside and outside cylinder. The research can provide theoretical significance for the optimization design of CCL structures.

Key words: fluid mechanics, concentric canister launcher, secondary combustion, dynamic mesh update method, guider

中图分类号:

TJ768

胡晓磊，乐贵高，马大为，朱忠领. 同心筒发射燃气流二次燃烧数值研究及导流板结构改进[J]. 兵工学报, 2014, 35(1): 62-69.

HU Xiao-lei, LE Gui-gao, MA Da-wei, ZHU Zhong-ling. Numerical Simulation of Secondary Combustion Gas Field in Concentric Canister Launcher and Improvement Measures of Guider[J]. Acta Armamentarii, 2014, 35(1): 62-69.

参考文献

［1］ Yagla J J. Concentric canister launcher[J]. Naval Engineer Journal，1997，1(9)：313-327.
[2］张光喜，周为民，张钢锤，等.固体火箭发动机尾焰流场特性研究[J].固体火箭技术，2008，31(1)：19-23.
ZHANG Guang-xi，ZHOU Wei-min，ZHANG Gang-chui，et al. Study on characteristics of flow field in exhaust plu-me for SRM[J]. Journal of Solid Rocket Technology，2008，31(1)：19-23. (in Chinese)
[3］苗佩云，袁曾凤. 同心筒式发射时筒内流场机理及内外筒间隙的影响[J]. 战术导弹技术，2006，29(1)：8-13.
MIAO Pei-yun，YUAN Zeng-feng. The effect of flow mechanism and annular sizes on concentric canister launcher[J]. Tactical Missile Technology， 2006，29(1)：8-13. (in Chinese)
[4］熊永亮，郜冶，李燕良. 同心筒发射中旁泄流影响的数值研究[J].弹箭与制导学报，2007，27(4)：194-197.
XIONG Yong-liang，GAO Ye，LI Yan-liang. Numerical investigate the influence of the side releasing flow on the concentric canister launch[J]. Journal of Projectiles，Rocket，Missiles and Guidance, 2007，27(4)：194-197. (in Chinese)
[5］蔺翠郎，毕世华. 同心发射筒内燃气流温度场的数值模拟[J].弹箭与制导学报，2007，27(5)：160-162.
LIN Cui-lang，BI Shi-hua. Numerical simulation of the combustion-gas temperature field in concentric canister launcher[J]. Journal of Projectiles，Rockets，Missiles and Guidance， 2007，27(5)： 160-162. (in Chinese)
[6］姜毅，郝继光，刘群. 同心筒垂直发射装置排导燃气的改进[J]. 北京理工大学学报，2007，27(2)：95-99.
JIANG Yi，HAO Ji-guang，LIU Qun. Improvement measures of exhausting the jet in the concentric vertical launching equipment[J]. Transaction of Beijing Institute of Technology， 2007，27(2)：95-99. (in Chinese)
[7］姜毅，郝继光，傅德彬. 导弹发射过程三维非定常数值模拟[J].兵工学报，2008，29(8)：911-915.
JIANG Yi，HAO Ji-guang，FU De-bin. 3D unsteady numerical simulation of missile launching[J]. Acta Armamentarii， 2008，29(8)： 911-915. (in Chinese)
[8］姜毅，郝继光. 新型“引射同心筒”垂直发射装置理论及实验研究[J]. 宇航学报，2008，29(1)：236-241.
JIANG Yi, HAO Ji-guang. Study on theory and test of a new type “concentric canisterwith jet flow” vertical launcher[J]. Journal of Astronautics，2008，29(1)：236-241. (in Chinese)
[9］何朝勋，戴宗妙. 同心筒式发射装置燃气排导研究[J]. 舰船科学技术，2007，29(1)：71-75.
HE Chao-xun，DAI Zong-miao. Research into the jet exhaust of concentric canister launcher[J]. Ship Science and Technology，2007，29(1)：71-75. (in Chinese)
[10］于勇，徐新文，傅德彬. 同心筒发射装置燃气排导的气体动力学原理分析[J]. 航空动力学报，2012，27(3)：501-507.
YU Yong，XU Xin-wen，FU De-bin. Aerodynamic theory analysis of gas exhausting from concentric canister launcher[J]. Journal of Aerospace Power，2012，27(3)：501-507. (in Chinese)
[11］ Shu C W，Osher S. Efficient implementation of essentially non-oscillatory shock capturing schemesⅡ[J]. Journal of Computational Physics, 1989，83：32-78.
[12］ Shih T H, Liou W W, Shabbir A, et al. A new k-ε eddy-viscosity model for high reynolds number turbulent flows-model development and validation[J]. Computers & Fluids，1995，24(3)：227-238.
[13］ Jensen D E，Jones G A. Reaction rate coefficients for Flame calculations[J]. Combustion and Flame，1978，32：1-34.
[14］ Troyes J， Boischot A. Multi-phase reaction numerical simulations of a model solid rocket motor exhaust jet［R］. California: American Institute of Aeronautics and Astronautics,2006: 1-13.

[1]	李仁凤，乐贵高，马大为. 燃烧产物特性对燃气弹射内弹道与载荷的影响研究[J]. 兵工学报, 2016, 37(2): 245-252.
[2]	胡晓磊，乐贵高，马大为，任杰，周晓和. 环形腔对燃气弹射初容室二次燃烧影响数值研究[J]. 兵工学报, 2015, 36(6): 1024-1032.
[3]	王洪远，徐义华，胡旭，曾卓雄. 空气旋转进气对含硼固体冲压发动机二次燃烧性能影响的研究[J]. 兵工学报, 2015, 36(4): 619-625.
[4]	余文杰，余永刚. 环境压力降低对底排二次燃烧影响的数值模拟[J]. 兵工学报, 2015, 36(3): 443-450.
[5]	李代金，罗凯，党建军，王育才，张宇文. 超空泡水下航行器空间运动建模与弹道仿真[J]. 兵工学报, 2012, 33(8): 956-961.

同心筒发射燃气流二次燃烧数值研究及导流板结构改进

Numerical Simulation of Secondary Combustion Gas Field in Concentric Canister Launcher and Improvement Measures of Guider

PDF

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 5

编辑推荐

Metrics

本文评价