Cylinder Test and Equation of State for DNAN-based Aluminized Melt-cast Explosive

doi:10.3969/j.issn.1000-1093.2021.07.009

Abstract

Abstract: To determine the parameters of equation of state (EOS) for detonation products in the shock initiation of aluminized explosives, a series of 50 mm standard cylinder tests was performed for the DNAN-based aluminized RA1 melt-cast explosive (HMX/DNAN/Al) and its corresponding explosive RF1 (HMX/DNAN/LiF) that contains the lithium fluoride (LiF). The detonation velocities of two kinds of explosives and the expanding velocities of cylinders were measured by using the electric probes and the photonic Doppler velocimetry (PDV). The EOS parameters for detonation products of RA1 and RF1 are both determined by genetic algorithm and numerical simulation. It is found that the wall velocity histories of RA1 and RF1 are almost consistent within 0-4.6 μs, but separate obviously after 4.6 μs due to the increasing reaction degree of aluminum powder. This indicates that the aluminum powder mainly reacts in the expansion process of detonation products, and hardly participates in chemical reaction during the detonation as well as the shock initiation. Therefore, in the numerical simulation of shock initiation, the detonation products of the aluminized explosives can be described by the EOS for the detonation products of their corresponding explosives that contain the lithium fluoride.

Key words: aluminizedexplosive, ordnancescienceandtechnology, cylindertest, equationofstate, shockinitiation, lithiumfluoride

CLC Number:

TQ564.2
O381

LI Shurui， DUAN Zhuoping， ZHENG Baohui， LUO Guan， HUANG Fenglei. Cylinder Test and Equation of State for DNAN-based Aluminized Melt-cast Explosive[J]. Acta Armamentarii, 2021, 42(7): 1424-1430.

References

［1］ STEVEN N, JOHN N, PAMELA F. Recent developments in reduced sensitivity melt pour explosives[C]∥Proceedings of the 34th International Annual Conference of the Fraunhofer ICT. Karlsruhe, Germany: the Fraunhofer Institute for Chemical Technology, 2003.
[2］董海山. 钝感弹药的由来及重要意义[J]. 含能材料, 2006, 14(5):321-322.
DONG H S. Origin and significance of insensitive munitions[J]. Chineses Journal of Energetic Materials, 2006, 14(5):321-322. (in Chinese)
[3］ BAKER E L, STASIO A R D. Insensitive munitions technology development[J]. Problems of Mechatronics Armament, Aviation, Safety Engineering, 2014, 4(18):7-20.
[4］杨洋, 段卓平, 李淑睿, 等. 2, 4-二硝基苯甲醚基熔注炸药
RMOE-2冲击起爆实验研究[J]. 兵工学报, 2018, 39(增刊1):72- 76.
YANG Y, DUAN Z P, LI S R, et al. Experimental research on shock initiation for DNAN-based melt-cast RMOE-2 explosive[J]. Acta Armamentarii, 2018, 39(S1):72-76.(in Chinese)
[5］ FICKETT W, DAVIS W C. Detonation[M]. Berkeley, CA, US: University of California Press, 1979.
[6］ COWPERTHWAITE M. Non-ideal detonation in a composite CHNO explosive containing aluminum[C]∥Proceedings of the 10th International Detonation Symposium. Boston, MA, US: Office of Naval Research, 1993.
[7］陈朗, 龙新平, 冯长根, 等. 含铝炸药爆轰[M]. 北京: 国防工业出版社, 2004.
CHEN L, LONG X P, FENG C G. Detonation of aluminized explosive[M]. Beijing: National Defense Industry Press, 2004. (in Chinese)
[8］ MANNER V W, PEMBERTON S J, GUNDERSON J A, et al. The role of aluminum in the detonation and post-detonation expansion of selected cast HMX-based explosives[J]. Propellants, Explosives, Pyrotechnics, 2012, 37(2):198-206.
[9］孙承纬, 卫玉章, 周之奎. 应用爆轰物理[M]. 北京: 国防工业出版社, 2000.
SUN C W, WEI Y Z, ZHOU Z K. Applied detonation physics[M]. Beijing: National Defense Industry Press, 2000. (in Chinese)
[10］ KURY J W. Metal acceleration by chemical explosives[C]∥Proceedings of the 4th International Symposium on Detonation. Arlington, VA, US: Office of Naval Research, 1965.
[11］ FRIED L E, SOUERS P C. BKWC: an empirical BKW parametrization based on cylinder test data[J]. Propellants, Explosives, Pyrotechnics, 1996, 21(4):215-223.
[12］韩勇, 黄辉, 黄毅民, 等. 含铝炸药圆筒试验与数值模拟[J]. 火炸药学报, 2009, 32(4):14-17.
HAN Y, HUANG H, HUANG Y M, et al. Cylinder test of aluminized explosives and its numerical simulation[J]. Chineses Journal of Explosives & Propellants, 2009, 32(4):14-17. (in Chinese)
[13］ ELEK P M, DINGALAEVI V V, JARAMAZ S S, et al. Determination of detonation products equation of state from cylinder test: analytical model and numerical analysis[J]. Thermal Science, 2015, 19(1):35-48.
[14］裴红波, 钟斌, 李星瀚, 等. RDX基含铝炸药圆筒试验及状态方程研究[J]. 火炸药学报, 2019, 42(4):403-409.
PEI H B, ZHONG B, LI X H, et al. Study on the culinder tests and equation of state in RDX based aluminized explosives[J]. Chinese Journal of Explosives & Propellants, 2019, 42(4):403-409. (in Chinese)
[15］ GUSTAVSEN R L, BARTRAM B D, SANCHEZ N. Detonation wave profiles measured in plastic bonded explosives using 1 550 nm photon Doppler velocimetry (PDV): LA-UR-09-4939[R]. Los Alamos, NM, US: Los Alamos National Laboratory, 2009.
[16］刘海庆, 段卓平, 蔡进涛, 等. 准等熵加载下PBXC03炸药起爆响应特性实验研究[J]. 北京理工大学学报, 2018, 38(8): 792-796.
LIU H Q, DUAN Z P, CAI J T, et al. Experimental research of characteristics of initiation response of PBXC03 under quasi-isentropic loading[J]. Transactions of Beijing Institute of Technology, 2018, 38(8):792-796. (in Chinese)
[17］ PEI H B, HUANG W B, ZHANG X, et al. Measuring detonation wave profiles in plastic-bonded explosives using PDV[J]. AIP Advances, 2019, 9: 015306.
[18］ YANG Y, DUAN Z P, ZHANG L S, et al. Measurements of reaction zone and determination of the equation of state parameters of DNAN-based melt-cast aluminized explosive[J]. Journal of Energetic Materials, 2020, 38(2): 240-251.
[19］ RUMCHIK C G, NEP R, BUTLER G C, et al. The miniaturization and reproducibility of the cylinder expansion test[J]. AIP Conference Proceedings, 2012, 1426(1):450-453.
[20］ KNZEL M, NMEC O, PACHMAN J. Optimization of wall velocity measurements using photonic doppler velocimetry (PDV)[J]. Central European Journal of Energetic Materials, 2015, 12(1): 89-97.
[21］ JARNHOLT G B. Effects of aluminum and lithium flouride admixtures on metal acceleration ability of Comp B[C]∥Procee- dings of the 6th International Symposium on Detonation. Coronado, CA, US: Office of Naval Research, 1976.
[22］温丽晶, 段卓平, 张震宇, 等. 采用遗传算法确定炸药爆轰产物JWL状态方程参数[J]. 爆炸与冲击, 2013, 33(增刊1): 130- 134.
WEN L J, DUAN Z P, ZHANG Z Y, et al. Determination of JWL-EOS parameters for explosive detonation products using genetic algorithm[J]. Explosion and Shock Waves, 2013, 33(S1): 130-134. (in Chinese)
[23］ MILLER P J, GUIRGUIS R H. Experimental study and model calculations of metal combustion in Al/AP underwater explosives[J]. MRS Online Proceedings Library: Symposium Y-Structure and Properties of Energetic Materials, 1992, 296:299-304.

[1]	LI Shurui， DUAN Zhuoping， BAI Zhiling， ZHANG Xu， HUANG Fenglei. Shock Initiation Characteristics of DNAN-based Aluminized Melt-cast Explosive [J]. Acta Armamentarii, 2022, 43(6): 1288-1294.
[2]	KAN Runzhe， NIE Jianxin， GUO Xueyong， YAN Shi， JIAO Qingjie， ZHANG Tao. Energy Output Characteristics of CL-20-based Aluminized Explosives with Different Al/O Ratios during Deep-water Explosion [J]. Acta Armamentarii, 2022, 43(5): 1023-1031.
[3]	HE Xiang, YAN Nan, ZENG Xiangtao, XIE Ruizhen, BAO Bingliang, ZHANG Liang, WU Weiming. Relation among Important Structural ParametersFlyer Velocity and Energy of Flyer Driven by Micro-size Lead Azide [J]. Acta Armamentarii, 2021, 42(7): 1363-1371.
[4]	WANG Hongfu， BAI Fan， LIU Yan， DUAN Zhuoping， HUANG Fenglei. Ignition Reaction Rate Model of RDX-based Aluminized Explosives under Shock Waves [J]. Acta Armamentarii, 2021, 42(2): 327-339.
[5]	YAO Chengbao, FU Meiyan, HAN Feng, YAN Kai, LEI Yu. A Numerical Scheme for Fluid-solid Interactions Based on Multi-medium Riemann Problem and Its Application in Explosion andImpact Problems [J]. Acta Armamentarii, 2021, 42(2): 340-355.
[6]	ZHAO Pin， CHEN Lang， LI Jinhe， LU Jianying， WU Junying. The Characteristics of Explosives Initiated by Precursor Shock Waves in Shaped Charge Jet Penetrating a Bulkhead at DifferentTemperatures [J]. Acta Armamentarii, 2021, 42(1): 45-55.
[7]	LI Kebin， DONG Xinlong， LI Xiaojie， YAN Honghao， WANG Xiaohong. Research on Parameters Determination of JWL EOS for Commercial Explosives Based on Underwater Explosion Test [J]. Acta Armamentarii, 2020, 41(3): 488-494.
[8]	LIU Rongqiang， NIE Jianxin， JIAO Qingjie， XU Xinchun. ZHANG ChuanqingSONG Haijun（239）Simulation Analysis of Influencing Factors of Flyer Driven by Small-size JO-9C Booster Explosive [J]. Acta Armamentarii, 2020, 41(2): 246-253.
[9]	WU Yachen, SHEN Chen, SUN Xiaole, JIAO Qingjie, LIU Hailun, YAN Shi. Metal Accelerating Ability of Castable CL-20-based PBX [J]. Acta Armamentarii, 2020, 41(12): 2458-2465.
[10]	ZHAO Xingyu, BAI Chunhua, YAO Jian, SUN Binfeng. Parameters Calculation of JWL EOS of FAE Detonation Products [J]. Acta Armamentarii, 2020, 41(10): 1921-1929.
[11]	MIAO Feichao， ZHOU Lin， ZHANG Xiangrong， CAO Tongtang. Implantation and Application of Ignition and Growth Reaction Rate Equation in LS-DYNA Software [J]. Acta Armamentarii, 2019, 40(7): 1411-1417.
[12]	KOU Yongfeng， CHEN Lang， MA Xin， ZHAO Pin， LU Jianying， WU Junying. Cook-off Experimental and Numerical Simulation of RDX-based Aluminized Explosives [J]. Acta Armamentarii, 2019, 40(5): 978-989.
[13]	LI Rui, LI Weibing, JIN Hongzhong, WANG Guilin, HONG Xiaowen, ZHU Jianjun, LI Wenbin, WANG Xiaoming. Theoretical Analysis about Interaction Parameters of Detonation Waves Based on Jones-Wilkins-Lee Equation of State [J]. Acta Armamentarii, 2019, 40(3): 516-521.
[14]	RONG Jili， ZHAO Zitong， FENG Zhiwei， WEI Huiyang， PAN Hao， XU Hongtao， XIN Pengfei. Experimental Study of Underwater Explosion Performance of RDX-based Aluminized Explosive [J]. Acta Armamentarii, 2019, 40(11): 2177-2183.
[15]	MA Kun, LI Mingrui, CHEN Chunlin, FENG Na, ZHAO Nan, KE Ming, ZHOU Gang. Simulation Analysis of Distribution of Fragments of Hypervelocity 93W Projectile Impacting on a Steel Plate Target [J]. Acta Armamentarii, 2019, 40(10): 2022-2031.