欢迎访问《兵工学报》官方网站,今天是 分享到:

兵工学报 ›› 2020, Vol. 41 ›› Issue (5): 833-841.doi: 10.3969/j.issn.1000-1093.2020.05.001

• 论文 • 上一篇    下一篇

弹丸在炮口的状态参数对地面密集度影响研究

钱林方1, 陈光宋2, 王明明2   

  1. (1.西北机电工程研究所, 陕西 咸阳 712099; 2.南京理工大学 机械工程学院, 江苏 南京 210094)
  • 收稿日期:2020-02-24 修回日期:2020-02-24 上线日期:2020-07-17
  • 作者简介:钱林方(1961—), 男, 教授, 博士生导师。 E-mail: lfqiang@njust.edu.cn
  • 基金资助:
    国家自然科学基金项目(11472137)

The Effects of Initial State Parameters of Projectiles at Muzzle on Their Ground Dispersion

QIAN Linfang1, CHEN Guangsong2, WANG Mingming2   

  1. (1.Northwest Institute of Mechanical and Electrical Engineering, Xianyang 712099, Shaanxi, China; 2.School of Mechanical Engineering, Nanjing University of Science and Technology, Nanjing 210094, Jiangsu, China)
  • Received:2020-02-24 Revised:2020-02-24 Online:2020-07-17

摘要: 为了分析无动力飞行弹丸在炮口的状态参数误差对地面密集度影响,基于6自由度刚体外弹道方程,考虑弹丸参数和炮口状态参数误差因素,利用稀疏网格数值积分(SGNI)方法求解弹丸落点散布的统计特性参数,并采用最大熵估计方法获得弹丸落点散布的概率密度函数。测试算例表明,该方法的计算结果与蒙特卡洛方法获得的结果相吻合,验证了SGNI方法和最大熵估计方法的有效性;在此基础上分析了某155 mm加榴炮弹丸在炮口的状态参数误差对地面密集度影响,并分别建立了弹丸在炮口的单参数误差、多参数误差与地面密集度之间的映射模型,可为火炮射击密集度总体设计提供参考。

关键词: 火炮, 密集度, 外弹道, 稀疏网格数值积分, 最大熵方法

Abstract: The effects of the state parameters of projectiles at muzzle on the dispersion of projectiles are analyzed. Based on the six-degree-of-freedom ballistic equations, the sparse grid numerical integration (SGNI) method is used to obtain the characteristic paramerers of projectiles dispersion considering the error factors of system parameters and the state parameters of projectile at muzzle. The probability distribution of projectiles dispersion is obtained by using the the maximum entropy method. The test examples show that the results obtained by the SGNI method are in good agreement with those obtained by Monte Carlo method, and verify its effectiveness. In addition, an engineering example of 155 mm gun-howitzer is ananlyzed, and the the relation between single state parameter error and multi-state parameter error and the projectiles dispersionis established, which can be provided as reference for the overall design cosidering the dispersion of projectiles. Key

Key words: artillery, dispersion, exteriorballistics, sparsegridnumericalintegration, maximumentropymethod

中图分类号: