40CrMnSiB钢圆柱壳体膨胀断裂中间状态回收试验研究

doi:10.3969/j.issn.1000-1093.2018.11.007

兵工学报 ›› 2018, Vol. 39 ›› Issue (11): 2137-2144.doi: 10.3969/j.issn.1000-1093.2018.11.007

40CrMnSiB钢圆柱壳体膨胀断裂中间状态回收试验研究

陈志闯，李伟兵，朱建军，王晓鸣，李文彬

（南京理工大学智能弹药技术国防重点学科实验室，江苏南京 210094）

收稿日期:2018-03-05 修回日期:2018-03-05 上线日期:2018-12-25
通讯作者: 李伟兵 (1982—)，男，副教授，博士生导师 E-mail:njustlwb@163.com
作者简介:陈志闯 (1995—)，男，硕士研究生。 E-mail: nust_chen@163.com
基金资助:
国家自然科学基金项目（11202103）；江苏省研究生科研与实践创新计划项目（SJCX17_0119）

Recovery Experiment Study of Cylindrical 40CrMnSiB Steel Shell in Intermediate Phase of Expanding Fracture Processes

CHEN Zhi-chuang， LI Wei-bing， ZHU Jian-jun， WANG Xiao-ming， LI Wen-bin

(Ministerial Key Laboratory of ZNDY，Nanjing University of Science and Technology，Nanjing 210094，Jiangsu，China)

Received:2018-03-05 Revised:2018-03-05 Online:2018-12-25

摘要/Abstract

摘要： 针对回火温度条件对金属圆柱壳体膨胀断裂动态过程的影响问题，设计了冻结回收试验，用于回收处于膨胀断裂状态的金属壳体断裂形貌。以200 ℃、350 ℃、500 ℃和600 ℃ 4种回火温度处理下的40CrMnSiB钢为研究对象，通过冻结回收试验获得了4种回火温度状态下壳体断裂中间状态，分析了不同回火温度对壳体断裂、裂纹萌生、扩展及分布的影响，揭示了回火温度对40CrMnSiB钢圆柱壳体宏观断裂特性的影响规律。研究结果表明：随着回火温度从200 ℃上升到600 ℃，初期受动态塑性及断裂韧性改善的影响,壳体的断裂相关参量变化明显，后期材料动态强度减小造成的影响更突出，断裂相关参量基本不变；在500 ℃回火状态下的壳体断裂应变最大，相对于200 ℃回火状态提高了48.1%.

关键词: 金属圆柱壳体, 膨胀断裂, 回火温度, 断裂应变, 冻结回收试验

Abstract: To understand the influence of tempering temperature on the dynamic process of expansion and fracture of cylindrical metal shell, a recovery experiment is designed to recover the fracture morphologies of metal shells at the intermediate phase of explosion. The 40CrMnSiB steels tempered at 200 ℃, 350 ℃, 500 ℃, and 600 ℃ are used as the research objects. The intermediate states of fractures of cylindrical metal shells at four different tempering temperatures were obtained through the recovery experiment. On this basis, the effects of different tempering temperatures on the fracture pattern, crack initiation, propagation and distribution are analyzed, and the influence rule of tempering temperatures on the macroscopic fracture characteristics of cylindrical 40CrMnSiB steel shells is revealed. The result shows that, as the tempering temperature is increased from 200 ℃ to 600 ℃, the fracture characteristic parameters of shell are influenced by the improvement in dynamic plasticity and fracture toughness and change significantly at the initial stage; at the later stage, the effect caused by the decrease in the dynamic strength of material is more prominent, so these parameters are essentially constant. The fracture strain of metal shell tempered at 500 ℃ is maximal, which is increased by 48.1% compared with that tempered at 200 ℃. Key

Key words: cylindricalmetalshell, expandingfracture, temperingtemperature, fracturestrain, recoveryexperiment

中图分类号:

TJ410.6

陈志闯，李伟兵，朱建军，王晓鸣，李文彬. 40CrMnSiB钢圆柱壳体膨胀断裂中间状态回收试验研究[J]. 兵工学报, 2018, 39(11): 2137-2144.

CHEN Zhi-chuang， LI Wei-bing， ZHU Jian-jun， WANG Xiao-ming， LI Wen-bin. Recovery Experiment Study of Cylindrical 40CrMnSiB Steel Shell in Intermediate Phase of Expanding Fracture Processes[J]. Acta Armamentarii, 2018, 39(11): 2137-2144.

参考文献

［1］ Gurney R W. The initial velocities of fragments from bombs, shell and grenades[R].Aberdeen, MD, US: Army Ballistic Research Laboratory, 1943.
[2] Taylor G I.The fragmentation of tubular bombs[M]. Batchelor C K.Scientific Papers of Sir Geoffrey Ingram Taylor: 3. Cambridge, UK: Cambridge University Press, 1963: 387-390.
[3] Balagansky I A, Karanik Y A, Agureikin V A , et al. Fracture behavior of explosively loaded spherical molded steel shells[J].Theoretical and Applied Fracture Mechanics, 2001, 36(2):165-173.
[4] 金山, 汤铁钢, 孙学林, 等. 不同热处理条件下45钢柱壳的动态性能[J].爆炸与冲击, 2006, 26(5):423-428.
JIN Shan,TANG Tie-gang, SUN Xue-lin, et al. Dynamic characteristic of 45 steel cylinder shell by different heat treatment conditions [J]. Explosive and Shock Wave, 2006, 26(5):423-428.(in Chinese)
[5] 任国武, 郭召亮, 汤铁钢,等. 高应变率加载下金属圆柱壳体断裂的实验研究[J].兵工学报, 2016, 37(1):77-82.
REN Guo-wu, GUO Zhao-liang, TANG Tie-gang, et al. Experimental research on fracture of metal case under loading at high strain rate[J].Acta Armamentarii, 2016, 37(1): 77-82.(in Chinese)
[6] Zhu J J, Li W B, Wang X M, et al. Study on the expansion and fracture of a cylindrical 50SiMnVB steel shell under different tempering temperatures[C]∥Proceedings of the 29th International Symposium on Ballistics.Edinburgh, UK: International Ballistics Society, 2016:1630-1640.
[7] Zhu J J, Li W B, Wang X M, et al.Effect of tempering temperature on expansion and fracture mechanism of 40CrMnSiB steel cylinder shell[J].International Journal of Impact Engineering, 2017, 107:38-46.
[8] Arnold W.Fragment mass distribution of metal cased explosive charges[J].International Journal of Impact Engineering, 2008, 35(12): 1393-1398.
[9] 朱建军, 李伟兵, 王晓鸣,等.回火温度对50SiMnVB钢壳体形成破片性能的影响[J].兵工学报,2015, 36(11): 2080-2086.
ZHU Jian-jun, LI Wei-bing, WANG Xiao-ming, et al.Effect of tempering temperature on the forming properties of fragments of 50SiMnVB steel shell [J]. Acta Armamentarii, 2015, 36(11): 2080-2086. (in Chinese)
[10] Taylor G I. Analysis of the explosion of a long cylindrical bomb detonated at one end[M]. Batchelor C K. Scientific Papers of Sir Geoffrey Ingram Taylor: 3. Cambridge, UK: Cambridge University Press, 1963:277-286.
[11] Zhu J J, Li W B, Wang X M, et al.Mid-explosion recovery of an intermediate phase of a cylindrical shell [J].Combustion, Explosion, and Shock Waves, 2018, 54(2):246-254.
[12] Hu H B, Tang T G, Hu B Y, et al. Longitudinal propagation of fracture surface in cylindrical metal shells under explosive loading[C]∥Proceedings of the 15th APS Topical Conference on Shock-Compression of Condensed Matter. Waikoloa, HI, US: American Institute of Physics, 2007: 541-544.

第39卷第11期
2018 年11月兵工学报ACTA
ARMAMENTARIIVol.39No.11Nov. 2018

[1]	朱建军，李伟兵，李文彬，王晓鸣，郑宇，卢海涛，袁书强. 高应变率下金属柱壳动态变形及形成破片特性研究[J]. 兵工学报, 2017, 38(10): 1933-1941.
[2]	朱建军，李伟兵，王晓鸣，程兴旺，李文彬，卢海涛. 回火温度对50SiMnVB钢壳体形成破片性能的影响[J]. 兵工学报, 2015, 36(11): 2080-2086.

40CrMnSiB钢圆柱壳体膨胀断裂中间状态回收试验研究

Recovery Experiment Study of Cylindrical 40CrMnSiB Steel Shell in Intermediate Phase of Expanding Fracture Processes

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

编辑推荐

Metrics

本文评价